63/64 Cadillac Website

63 Coupe deVille for sale

I have a 63 CDV with factory bucket seats for sale. Engine runs and I have not driven the car.

44,000m miles, clean AZ title. I believe this is a California car as there is an emissions sticker on the rad core support.

Factory power bucket seats with center console.

Air Conditioning, tilt steering wheel, power vent windows. Power door locks, power trunk release, seat belts.

Car is rust free with some pin holes in the front floor pans at the foot wells. All 4 factory rims with hubcaps and skirts.

back bumper is dented, a good clean bumper is included. Front bumper is dented in and a good clean front bumper is included. Radio, LH door panel are in the trunk. The door panel will need to be redone.

Lots of extra parts to fix the damaged or missing parts. All of the side trim is included.

car is in Vail AZ $6,000.00 If you want to negotiate on the price, then the extra parts will be removed from the sale.

Please email me at russ@thecadishack.com to inquire about the car. not be included.

0 members like this

Facebook Facebook

▶ Reply to This

Welcome to
63/64 Cadillac Website

Sign Up
or Sign In

Or sign in with:

Photos

Members

View All

Forum

seat foam replacement

Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 2 hours ago. 1 Reply 0 Likes

does anyone out there have any experience with seat foam replacement on a 63/64 Cadillac. I had my seats reupolstered many years ago in original leather/fabric and they still look great, but the…Continue

1963 carter afb carbureter stainless steel shim

Started by tim sparks in General Discussion 3 hours ago. 0 Replies 0 Likes

anybody have an xtra stainless steel shim for 1963 carter afb carb. thank youContinue

Timing cover corrosion

Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 11 hours ago. 1 Reply 0 Likes

Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue

Convertible bumper jack

Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 18 hours ago. 13 Replies 0 Likes

My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue