I am not having issues with with my vacuum unit but have been looking at what it would take to replace it if became necessary. Can the 2 nuts that hold it to the rear plenum be reached from the inside without removing the plenum? The rear plenum is very close to the firewall and it appears that space is quite limited to access the nuts on the backside of the plenum.

Views: 127

Reply to This

Replies to This Discussion

I did mine working from inside with the glove box liner removed. Posted here https://6364cadillac.ning.com/forum/topics/recirculation-actuator-r...

The vacuum unit you are showing has already been replaced. The unit I am speaking about controls the flow of air between the floor/ac ducts. It is mounted inside the rear half of the heat/ac assembly and the retaining nuts are facing the firewall.

Ah, I see. I haven't had the pleasure of replacing that yet.

RSS

Photos

  • Add Photos
  • View All

Forum

Clock Repair

Started by Michael Vogler in General Discussion. Last reply by Dennis P. DiBari Mar 22. 6 Replies

63/63 Owners,The clock in my '64 just went out. It appears that the mechanical component is working properly, so I think the coil has failed. I contacted Jerry at Clockworks and he advised that he…Continue

No dash lights, headlights only come on with dimmer

Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton Mar 22. 6 Replies

I’m in the midst of refreshing some things in my dash. I got my passenger ash tray working for the first time ever apparently, evident by the factory defect tag. “While I’m in here I might as well…Continue

Burning Rubber

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler Mar 22. 14 Replies

Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light?   Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue

Down and Out for a Couple of Weeks --> but On the Mend

Started by Jason Edge in General Discussion. Last reply by Michael Vogler Mar 22. 3 Replies

I have been more than a bit quiet the past couple of weeks due to a really bad fall January 31 where I tore my right knee MCL ligament and ruptured the ACL Ligament. MCL will heal in time but ACL is…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service