Hydramatic pics?
Does anyone have any good pics of the Hydramatic linkage? I'm trying to adjust the linkage per the shop manual. I have found that my manual rod is maxed out on adjustment which will not allow me to adjust it correctly. I suspect the manual lever is bent but I don't want to experiment with bending it until I know for sure what it should look like. The figures in the shop manual don't really help me determine what the lever should look like. Here's a pic of mine. The transmission is in park in the pic.
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
The lever is up side down in the bracket. Reposition the tab 180 deg and install it into the lever.
-
Permalink Reply by Kurt on
-
Yep. You are correct. I eventually figured that out. It's all good now. This started out as a NSS adjustment project. My reverse lights stayed on in Low too. After I adjusted the linkage I could then adjust the NSS. Reverse lights are good now but the NSS still leaks vacuum going from Dr to N. It's fine going from P->N->Dr, there is no vacuum leak but not so going the other direction. From Dr to N is leaks vacuum then going into P holds vacuum again.
Photos
Members
Forum
Rear Main Seal & Transmission Pump Seal
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by CHRIS CARLSON on Saturday. 1 Reply 0 Likes
Hey everyone, I need to replace my transmission input seal before spring starts, I’ve been losing a lot of fluid post Sunday drive. I figured I’d do the rear main seal service bulletin at the same…Continue
Heater Control Valve
Started by Michael Monson in Wanted to Buy. Last reply by Michael Monson on Thursday. 2 Replies 0 Likes
Looking for a heater control valve 9.795 for my 1964 Deville. ThanksContinue
64 Brakes
Started by Jeff Donaldson in General Discussion. Last reply by Logan Robb on Tuesday. 4 Replies 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Burning Rubber
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Kurt Feb 22. 7 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
