Just to share a few things:
- We will have our next Zoom meet-up this Sunday, Feb 23 at 7pm. I will send a notice out tomorrow with the link then again Sunday. If you cannot make it that is fine, just show up as you can. I will try to hopefully get back to a monthly schedule after missing January.
- I have surgery March 4 on my left elbow and wrist for Cubital Tunnel Syndrome (Carpels Evil Cousin), and have to say I am an absolute 100% true lefty, so many things including typing will be a challenge. It is a challenge now as my left hand feels dead on the left side without much feeling but hopefully surgery and several weeks of recovery will fix that. It has made typing a lot painful and difficult not to mention backing up and correcting my typing over and over! Argh.
- I hope to have the newsletter done before surgery... but we will see.
- I am trying to get a lot of physical stuff done before I have surgery and will go pick up my next batch of Cadmium plate fasteners and Parts this Monday, Feb 24. I figured if nothing else I can sort bolts with my right hand! I have also been trying to complete some yard projects including widening my white rock driveway which requires a lot of digging and moving dirt! I am getting there.
- Dino has been perched up in the 12" Race Ramps and I have started getting up under it more and cleaning, painting, and replacing some cadmium plated items. I will start posting pictures again of some of the upgrades.
- I will shut up for now, but will encourage everyone to use this site and post your questions, pictures, etc. I always like to read and see what you are all up to!
Jason.
Tags:
Hey Jason I know how you feel as Ive been glazier for the past 40 years my hands and shoulders are worn out and I suffer the same as you.I wish you all the best with your surgery
Hi Jason,
Good luck with your surgery on March 4th. I hope it is a quick recovery for you. All the best.
Dennis DiBari
Travis J. Hensley Online
Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 27 minutes ago. 1 Reply 0 Likes
Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 7 hours ago. 13 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Started by Bobby Brown in General Discussion. Last reply by Logan Robb 15 hours ago. 2 Replies 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
Started by Jason Edge in General Discussion. Last reply by Jason Edge on Saturday. 4 Replies 0 Likes
So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by