My bench seat switch circuit is dead. I found the hot wire cut under the seat, but cannot locate the other end of the hot wire. The wiring diagram indicates the it is connected to the rear cigar lighter hot. (See attached) Is this right? Does anyone have any thoughts about where I may be able to locate the or, or splice in? Thank you.
Tags:
All of the bench seat wiring feeds from the left side under the door sill plate. Remove the finish screws that hold the driver door sill plate down, remove plate, lift carpet and see the plastic wiring conduit. There is a cut out on inside neareast front corner of seat where the wire's "T-out" toward the seat. They are held down with a couple of red primer color clamps held with Phillips screws. See if you can see the other end of your wire and trace to the cut area and splice back if everything else looks OK.
Hmm, In my 63 CDV only the rear courtesy lights come on when the switch on the back of the front switch is turned on (according to owner's manual too). I believe the circuit works by grounding the lights with the pin switch in the door jambs or with the switch on the back of the front seat for the rear courtesy lights. It seems your switch is grounding for all interior lights. Could be bad door jamb switch(es) allowing the ground for all lights
I had an issue once where turning on the map light would also turn on the courtesy lights. It was the the pin switch allowing grounding of the courtesy lights. If not the pin switches, trace out what is allowing ground to all lights.
Without the 3 prong switch, 2 circuits are tied together meaning grounding one will ground the other. I guess you can chose whether to tie the map light to the front courtesy lights or leave it as is. A 3 prong switch is what you need to separate the circuits.
The 2 or 3 pin door jamb switch keeps the circuits separated. if you out in a single wire door jamb switch, all the lights will come on.
Scott Santora Online
Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 21 Replies 1 Like
Neither of my cornering lights are working. I started by focusing on drivers side. I removed the entire assembly and cleaned it up, replaced the wire to the socket, cleaned and lubricated the socket…Continue
Started by Doug Scarrow in For Sale yesterday. 0 Replies 0 Likes
just listed solid 1963 1964 non tilt steering wheel. https://www.ebay.com/itm/266784089004$120 plus shippingContinue
Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Wednesday. 9 Replies 0 Likes
I have a 64 Cadillac Deville convertible. When the wiper switch is turned on the washer pump activates continuosly no mater what speed is selected. Washer pump shuts off when wiper switch shut off.…Continue
Started by Russ Austin in For Sale. Last reply by Russ Austin on Wednesday. 2 Replies 0 Likes
I have 2 working T-3 low beam headlights and numerous T-3 high beam headlights for sale. Low beams are 22 each and high beams are 15.00 each plus shipping. Please email me at russ@thecadishack.com …Continue
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 0 Likes
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 0 Likes
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment 0 Likes
My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns.
There is a restoration service called The Horn Works who my son…
Continue© 2024 Created by Jason Edge. Powered by