I am looking to replace my battery for 64 DeVille. Any suggestions on the type and where to purchase?
Tags:
Check out Menards they have the big AC deacons batteries with top posts , check your dimensions of your old battery and the placement of the + & - posts and figure out if your hold down will work . Good luck
DELCO
You have a few choices. You can go all out and purchase a original style replica per this article from the Help topics tab in the header above: https://6364cadillac.ning.com/profiles/blogs/original-battery-and-c...
Personally I bought a group 24 Duracell battery from Batteries Plus Bulbs and have been happy with it, It is close to the size of the original battery, just slightly narrower - group 24:(10.25 x 6.8125 x 8.875) vs group 60: (13 1/16 x 6 5/16 x 8 7/8). It still fits nicely in the original battery tray. I did put some plastic strips along the right & left sides of the tray to take up the extra space. I also peeled off all the labels and dressed it up with some 3-D printed battery caps and a Delco label.
John, I just noticed you said your car is a 64. The battery hold-down was changed in 64 to go across the 13 1/6" length of the battery unlike my 63 where it goes front to back across 6 5/16" (6.8125"on group 24). As far a I can find now the group 60 replica is no longer produced. Unless you can find a similar sized battery, you will have to use a different hold-down. I'm sure some 64 guys will chime in with their solutions
Started by Bobby Brown in General Discussion. Last reply by Dennis P. DiBari 7 minutes ago. 1 Reply 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
Started by Jason Edge in General Discussion. Last reply by Jason Edge yesterday. 4 Replies 0 Likes
So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Thursday. 3 Replies 0 Likes
I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by