Hoisting engine
Im about to pull engine from car. I have removed valley pan, IM, undone exhaust from EM. Heads still on. Will b using a standard type lift. Hood off. Where is best place to hook up. Do i need one of those brackets. Looking for safest, easiest to manage method
Thanks
Replies to This Discussion
-
Permalink Reply by 1odsfdfteq279 on
-
Are you pulling the transmission with it? If so, I recommend one of these --> https://www.summitracing.com/parts/sum-g1021
It will help balance the load. I will be reinstalling the engine and trans back in my 64 as a unit, and this is the item I got.
When I pulled the engine out by itself, had the intake off of it, and I bolted my chain to two opposing ends at the manifold mounting location. It worked out fine.
-
-
Thanks, no. Jiat engine. ..so just pust two bolts in were intake attaches on each side and run chain across and up to lift mechanism?
-
-
I used a single chain, and attached it at pass side rear most intake man bolt hole, and driver side front most bolt hole. Hook the hoist at about center of chain and away you go!
-
-
10 4
Photos
Members
Forum
Burning Rubber
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 2 hours ago. 6 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Gas gauge only reads half when full
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue
64 Brakes
Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Heater Core Replacement
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson Feb 15. 6 Replies 0 Likes
I'm currently rounding up parts for a heater core replacement in my 1964 Deville. I'm looking for replacement hoses that connect to the heater core itself. It's a factory a/c car and has the metal…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
