Hydramatic pics?
Does anyone have any good pics of the Hydramatic linkage? I'm trying to adjust the linkage per the shop manual. I have found that my manual rod is maxed out on adjustment which will not allow me to adjust it correctly. I suspect the manual lever is bent but I don't want to experiment with bending it until I know for sure what it should look like. The figures in the shop manual don't really help me determine what the lever should look like. Here's a pic of mine. The transmission is in park in the pic.
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
The lever is up side down in the bracket. Reposition the tab 180 deg and install it into the lever.
-
Permalink Reply by Kurt on
-
Yep. You are correct. I eventually figured that out. It's all good now. This started out as a NSS adjustment project. My reverse lights stayed on in Low too. After I adjusted the linkage I could then adjust the NSS. Reverse lights are good now but the NSS still leaks vacuum going from Dr to N. It's fine going from P->N->Dr, there is no vacuum leak but not so going the other direction. From Dr to N is leaks vacuum then going into P holds vacuum again.
Photos
Members
Forum
Burning Rubber
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Linda M. Brooks yesterday. 5 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Gas gauge only reads half when full
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue
64 Brakes
Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Heater Core Replacement
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson on Sunday. 6 Replies 0 Likes
I'm currently rounding up parts for a heater core replacement in my 1964 Deville. I'm looking for replacement hoses that connect to the heater core itself. It's a factory a/c car and has the metal…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2026 Created by Jason Edge.
Powered by
