I need the front bench seat reupholstered with original style material. This is a 1963 Park Avenue with #44 Trim. If anyone can suggest a Cadillac experienced upholsterer it will be appreciated. thank you.

Facebook Facebook

Views: 201

Reply to This

Replies to This Discussion

SMS auto fabric stocks reproduction original materials.  Start there and get in touch with a local upholstery shop.

Thank you. I have contacted SMS and they will send a sample for me to check the match.

Just be aware they take time. A lot of time. Expect the sample in a month. After ordering and paying the full amount expect at least three months waiting before you have the materials.

Just to add, almost any upholstery shop with any history of working on old cars will be very aware of SMS Auto Fabrics. When I had my seats redone my local old school upholstery shop were able to order my Sandalwood Dover fabric for my seats direct from SMS st a discounted price.

   If you are doing just the front seats because the back ones are fine, and in many cases they are, make sure you get a large sample to make sure they match. They probably made different run lots and they can be a few shades off and you won't see it until until you reinstall them. A small sample may not show the difference.  I ran into this when I did my 76 Coupe De Ville.  good luck

RSS

Photos

  • Add Photos
  • View All

Forum

1963/64 Cadillac Chapter July 2025 Newsletter Posted

Started by Jason Edge in Newsletters 7 hours ago. 0 Replies

I have just completed and posted the July 2025, 1963/64 Cadillac Chapter Newsletter to our…Continue

Tags: Chapter, Newsletter, Posted, Cadillac, 1964

1963 AC evaporator core leaking?

Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton 18 hours ago. 4 Replies

Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue

Tags: 1963, core, evaporator, AC

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Tony Prichard yesterday. 4 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Power steering fluid

Started by Bobby Brown in General Discussion. Last reply by Tony Prichard yesterday. 7 Replies

My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service