#1 Is there a way to test the suction throttling valve?.  I have tested the vacuum power unit and it holds vacuum so i know the diaphragm is not leaking. Can you test the function of the valve itself without disassembling it or charging the system to see if it functions. The system will be charged with R12 . #2  Who rebuilds the original accumulator dryer with new desiccant besides classic auto air located in Tampa FL ?     I have a 1964 shop manual, it instructs you how to disassemble & repair it & adj it, but no test procedure to insure that it functions correctly. Thank you

Views: 65

Reply to This

Replies to This Discussion

#1 Other than testing the vacuum power unit, I don't know of a way to test the valve itself with a fully charged system. It is a simple valve with spring pressure (including the vac power unit) on one side & pressure from the freon in the evaporator on the other side. As long as it's clean & moving freely in the cylinder, it should be good. The weak component on these tends to be the STV diaphram (different than power unit diapram). If this leaks, your freon will escape. After a few have gone bad on me and they now want $115 for them, I converted my system to a clutch cycling system. So far I have been happy with it.

#2 I don't know who rebuilds them but bought a replacement at Autozone. It is slightly shorter that the original but wasn't hard to adapt the bracket to fit it. Are you going for 100% authenticity? 

 Kurt It's going to be a driver for now , but i like to keep it original. Where did you obtain that seal? do they fail regularly?

I have had leaks from this STV diaphram a few times over the years. It looks like Old Air Products and Original Air Group have them.

https://images.app.goo.gl/NKXfPL92EsooaYyM7

https://images.app.goo.gl/cfrwD5HHN2FHDf8q8

RSS

Photos

  • Add Photos
  • View All

Forum

1959 1960 Cadillac Transmission Bell Housing also 56 thru 1958 part 3632783

Started by Doug Scarrow in For Sale 11 hours ago. 0 Replies

just listed.  https://www.ebay.com/itm/266787800087Nice condition flywheel bell housing removed from a 1960 Cadillac also correct for late1956 thru…Continue

1958 thru 1964 Cadillac Jetaway Front Coupling Unit Complete

Started by Doug Scarrow in For Sale 11 hours ago. 0 Replies

just listed https://www.ebay.com/itm/266787800087Correct complete front unit coupling fits 1958 thru 1964 Cadillacs Hydramatic transmission The…Continue

cornering lights

Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 21 Replies

Neither of my cornering lights are working. I started by focusing on drivers side. I removed the entire assembly and cleaned it up, replaced the wire to the socket, cleaned and lubricated the socket…Continue

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service