Jason Engine Rebuild Project Pt 3 - Engine Complete

Jason Engine Rebuild Project Pt 3 - Engine Complete

Here are some pictures reloaded from the old site of my engine rebuild project. These pictures were taken May 6, 2012 after rebuild was complete and engine was ready to go in.

  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on September 15, 2012 at 8:41pm

The car was running fantastic today as we cruised down to the Clayton Harvest Festival Car Show and since I knew it might be a while before I can drive it as I replace the exhaust I changed out the metering rods to 4% richer for both cruise mode and power mode.   As good as it ran earlier now with the new richer metering rod jet configuration it is really running incredible.  I took it for one last spin before I start removing the custom dual exhaust and it is just really running great. It will be funny to hear it nice and quite when I get the new exhaust system installed, but couldn't help taking it out for one last blast before I start the change-out.  Just to back up a bit, when I had went from the ignitor II setup to the Ignitor III setup I returned the carb configuration to stock to get an ideal of  how the richer jets might improve with the III setup and it really makes a big difference!

Comment by Jason Edge on September 14, 2012 at 10:32pm

The engine now has 347 miles on it (162,278 on the car), and changes the oil for the first time since the rebuild.  I had planned to wait until 500 miles were on the engine but was anxious to change it now that I had least have some miles on it.  I'm running regular "on sale" 10W30 oil and wills switch to a semi-sythetic or all synthetic after 1000 miles are on the engine...which at my rate will be some time! :-)

Photos

  • Add Photos
  • View All

Forum

Headed to Birmingham Tomorrow!

Started by Jason Edge in General Discussion 14 hours ago. 0 Replies

I have been quiet lately, and just wanted to jump in an chat a minute. I have back to back visits to potential CLC  Winter Board and Grand National Sites, not to mention I have been pushing to get…Continue

On Busy Day Yesterday!

Started by Jason Edge in General Discussion 14 hours ago. 0 Replies

Very busy day working the parts cars yesterday, pulling engine and transmission out parts car #59, getting parts car #60 off the car hauler, then parts car back up on car hauler for final…Continue

Replacement 63 Radiator Recommendations

Started by Mike Travers in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth on Tuesday. 1 Reply

My 61 year old radiator sprung a leak (actually a few leaks). What are you guys using as replacements? Are you replacing with copper or aluminum? How many rows are you running in the radiator? How's…Continue

T-3 low beam headlight

Started by Jeff Donaldson in Wanted to Buy on Monday. 0 Replies

Hi,I need one T-3 low beam headlight if anyone has a spare they would like to sell.CheersJeffContinue

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Events

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service