My speedometer shows about 70 mls per hour when I drive 60. I checked it several times with my GPS. My Fleetwood does have a perfect working cruise control. Could it be the issue?
Is it possible to adjust the speedometer?

Views: 435

Facebook Facebook

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by David Thomas on May 9, 2013 at 4:09pm

Jason, very true, particularly if you have the standard get up, meaning tire size. In my case I had a lower overall ratio because I have smaller overall diameter tires from stock. What I did was essentially go back to stock gearing, overall. It is basically the same as it came from the factory but I'm running radials. If I ever went back to the bias ply tire, I would probably want to put the original pumpkin back in.

And you're right, when I went from a lower than factory gearing back closer to factory gearing, I did notice a slight decrease in off the line performance, not much, but a little.

Comment by Jason Edge on May 9, 2013 at 1:17pm
Changing out the rear end differential to a higher gear (lower #) is definitely one way to offset the speedometer inacurrancy due to shorter tires which effectively lowers the drive train to distance traveled ratio. That of course also alters other dynamics with a higher gear being better for highway cruising.... but not so good for stop and go city driving.
Comment by David Thomas on May 9, 2013 at 10:43am

My 63 with a/c had the 3.21 rear gears, I'm running 225 radials on it. My speedometer was about 10% fast. At 60 mph it registered 66 and it gained a tenth of a mile for every mile traveled. I drove it like that for years adjusting my mind for it to indicate 5 mph faster than I wanted to go. About a year or so back I found a 2.94 pumpkin and put that in. I didn't change the transmission speedometer gear. Now the speedometer indicates very close to the correct speed and mileage on the odometer.

Comment by Jason Edge on May 9, 2013 at 6:28am

Just to add, an excellent way to determine exactly how far off your speedometer is without having to take into a shop, is the next time you are on a trip in on the Interstates, note the mileage on your car at a particular mile post, and on the mile post 100 miles further on your trim note the exact reading on your odometer.   If your odometer reads say 102.6 miles you will know you are exactly 2.6% off.  

This was something I heard at the seminar on instrument gauges at the 2012 Grand National last year, and tried it out coming home up I-95 and found that my 305/45/22 tires put mile speedometer of by about 1.6% over from the shorter 305/40/22's had had been running.  In this case since I have taller tires than stock I'm traveling just a bit faster than the speedometer shows.

Comment by Jason Edge on May 8, 2013 at 7:27pm

The speedo head unit can definitely be off, especially if it has been bumped or handled.  I remember I got a speeding ticket WAY over the speed limit in my 1985 IROC Z and took the speedometer out, increased the gap between the magnet and outer metal speedo cup and it thirew that thing way off@ I took to local garage that would test and certify speedometer and it was off enough that they allowed my 105 in a 55 to be dropped to an 85 in a 55, and was able to get off with a PJC instead of losing my license.  If you are in college putting yourself through, you did whatever it took! LOL  Those were the days. Crazy thing thinking about it, is I just took the whole assembly out of that 85 Camaro sight unseen..no shop manual...just figured it out and did it!

Comment by Kurt on May 8, 2013 at 6:43pm

As a matter of fact I swapped out the gear from my parts car just to see if that would help my speedo inaccuracy. The parts car was non-ac & my CDV is an ac car. I was then getting about a +15 to 20 MPH difference depending on speed. If I remember correctly the 2.94 gear (non ac) has 11 teeth and the 3.21 gear (ac) has 13 teeth. Mine is a hydramatic so probably different than a TH.

Christian, I would be really surprised if that transmission shop swapped out this gear. Now if they swapped out the entire transmission, that's a different story.

Also to add, my truck which is a stock 2000 Silverado with stock tires is about 3 MPH off in the 70MPH range compared to the GPS. So, 10MPH could be inherent inaccuracy plus smaller tires in my opinion.

I know many of us are running smaller radial tires. Can anyone else chime in on how accurate their speedometer is with P235 75R15's? I assumed my problem was tire size but maybe the speedometer is just way off.

Comment by Christian Doerk on May 8, 2013 at 5:32pm
Ok, nice. Thank you. I will study the shop manual tomorrow ;)
Comment by Jason Edge on May 8, 2013 at 5:07pm

I will have the 3.21 AC gear for the Turbo Hydramatic transmission. 

It makes sense that if you use a speedometer gear for a 2.94 rear end but are using a 3.21 rear end, the speedometer would show about a 9% inaccuracy reading in the plus. 

As we all know a 2.94 rear end turns the wheels once with 2.94 revolutions of the driveshaft and the 3.21 turns the wheels once with 3.21 revolutions of the driveshaft. 

If you have a 2.94 speedo gear in transmission, but a 3.21 rear end, the 2.94 gear thinks the drivetrains is turning slower to go the same miles per hr, but if you actually have a 3.21 rear end (as your AC Fleetwood should), the drivetrain is spinning 9% faster to go the same speed...resulting in a 9% too fast reading on the speedometer.

Hope that is clear as mud! LOL

Jason.

Comment by Christian Doerk on May 8, 2013 at 4:53pm
I have to check my size of the tires too. But this huge difference?
Comment by Christian Doerk on May 8, 2013 at 4:44pm
The first owner serviced the transmission in the 90's as I know. Perhaps the service shop put in the speedometer gear for a non-ac car. Sounds logical!
I currently don't have the shop manual here. Is it described in the shop manual how to change the gear? Is it easy to change or do I have put apart the whole transmission? Do you have a correct gear for a ac-car, Jason?

Photos

  • Add Photos
  • View All

Forum

Original Rim Color

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Stinson 48 minutes ago. 3 Replies

When I get some new shoes for my 64 Fleetwood, I'd like to recondition the rims. I'd thought of getting them powder coated, and still plan to eventually, but the $700 quote I received shunted that…Continue

Replacement Front Crankshaft Seal - 1964 Eldorado (429ci)

Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Marty Smith 5 hours ago. 1 Reply

My mechanic is having difficulty sourcing a front crankshaft seal.  Can anyone recommend a replacement front crankshaft seal, and where to purchase?  Amazon has a few that I think(?) are replacements…Continue

Tags: Seal, Crankshaft, Front

Logans Intake Project, 1964 Fleetwood, Progress Report #2

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin yesterday. 1 Reply

Hello all!Just a short update this evening!I wrestled with the exhaust manifold studs and ultimately chickened out on replacing all 4 of the studs. I only replaced the stud that I spun the threads…Continue

Rear main seal

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson yesterday. 5 Replies

Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service