Christian Doerk
  • Male
  • Utting, Bavaria
  • Germany
Share on Facebook
Share

Christian Doerk's Friends

  • Nile Bolen
  • Tom Bahner
  • Tim sullivan
  • bavaricus
  • Bahama Sand
  • Cees de Bunje
  • Jimmy Davis
  • Leonhard
  • Russ Austin
  • David Murray
  • Jason Edge

Christian Doerk's Discussions

looking for a 429 heat riser and cruise control unit

Started this discussion. Last reply by Kurt Jul 6. 1 Reply

I am looking for a functioning heat riser valve and a cruise control for a 1964 Cadillac.In principle, the heat riser flap does not have to work. It is only important that the spacer / housing is not…Continue

Tags: exhaust, riser, heat, control, cruise

How to change AC compressor shaft seal?

Started this discussion. Last reply by Christian Doerk Jul 22. 17 Replies

My AC compressor is leaking from the groove I marked with the little screwdriver. It is a broken shaft seal, correct? Where can I get a new seal and do I really need the seal remover tool J-9392 for…Continue

1964 Cadillac Service Department (round table program) training on the Guide-Maric and Twilight Sentinel

Started this discussion. Last reply by Tony and Ginny 429 May 17. 5 Replies

Here is the second and currently also the last film. Digitized 1964 Cadillac Service Department (round table program) training for mechanics on Guide-Maric and Twilight Sentinel.Unfortunately, the…Continue

Tags: youtube, training, guide-matic, sentinel, twilight

1964 Cadillac Service Department (round table program) training for the Cadillac Comfort Control

Started this discussion. Last reply by Tony and Ginny 429 May 12. 9 Replies

I digitized the 1964 Cadillac Service Department (round table program) training for the Cadillac Comfort Control. Unfortunately, the original film had a violent red cast, which I did not get…Continue

Tags: YouTube, video, training, control, comfort

 

Christian Doerk's Page

Latest Activity

Christian Doerk and Nile Bolen are now friends
Oct 14
Christian Doerk replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"When the shop filled the system with R134a it was seal.I drove to a meeting with some friends to Austria with the AC on all the time at very warm weather and had a leak at the new shaft seal again. But probably the shop filled too much R134a. As I…"
Jul 22
Tony and Ginny 429 replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"Kurt i do hope your hose repair has turned out as well as expected so that when you show it off to your lady friends you get the desired response ( OH what a wonderful looking ——-Cadillac engine bay you have )  I could see it…"
Jul 21
Kurt replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"I took my hoses to a business that rebuilds hoses.They take the fittings and splice them to new barrier rubber hose. I used my original hoses for years with the A6 compressor running R134a with no issues. I just decided to replace the 56 year old…"
Jul 21
Kim K Kaiser replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"In additon to my steeering project,, i have been wanting to change the complressor on my 63 as well,, i read aobut those lighter replacemnt compressors.   Mine is the original and at a minimum,  the bearing is locked up,,, i had same…"
Jul 20
Kurt replied to Christian Doerk's discussion looking for a 429 heat riser and cruise control unit
"Here's an idea for the spacer: I don't know if you have access to a machine shop. Luckily for me, my neighbor is a machinist and made a spacer out of scrap metal when my heat riser cracked. He tried welding the heat riser first but he did…"
Jul 6
Christian Doerk posted a discussion

looking for a 429 heat riser and cruise control unit

I am looking for a functioning heat riser valve and a cruise control for a 1964 Cadillac.In principle, the heat riser flap does not have to work. It is only important that the spacer / housing is not broken or has a crack.Cruise control does not have to work 100% either. The shaft bushings must not be knocked out.Does anyone have something like that lying around?See More
Jul 6
Tony and Ginny 429 replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"Kurt STV eliminator kit is the right part to install when using. 134A  —so thank you for that  When the kit cycles the compressor as  It is designed to do (  it reduces compressor wear and affects gas mile in a…"
May 22
Kurt replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"I did a lot of research when I decided to upgrade my compressor. I have had other cars with A6 compressors in the past that leaked oil from the shaft seal running R12 and mineral oil. My research showed it was a common problem and there is…"
May 22
Anders replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"TA-Motor is recommending a recharge-kit from Duracool. I was planning to buy a kit and a new drier/accumulator and try it on my car. But now when reading about the leaking compressor I think that would be a waste of money. Guess the best plan of…"
May 22
Christian Doerk replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"Never heard of it!"
May 22
Tony and Ginny 429 replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"Regarding 134A when that might happen  Do you know about the after market part that when added  in will control the evaporated valve to produce the correct pressures with that Freon  and  cycle the compressor on and off ( more…"
May 22
Kevin Campbell replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"We haven't R12 in Australia for ages now. Three years ago I gassed up on R437A, that's now gone and R413A is the next one and its hard to get now. I think i'm going to end up with R134A when I change the compressor later in the…"
May 22
Christian Doerk replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"Lucky boy :)"
May 22
Mark S Anderson replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"I have r12 in all of my cadillacs (2) 1966 and (1) 1964.    I got a 30 pound container of it years ago, and I still have some leftover.   It's not even available in the USA anymore, but there is still old stock floating around…"
May 22
Christian Doerk replied to Christian Doerk's discussion How to change AC compressor shaft seal?
"Hi Mark, they are all filled with R134a but with mineral oil? Or do they still run all with R12? R12 is absolutely impossible to get or refilled here in Germany. "
May 22

Profile Information

Do you own any 1963 & 1964 Cadillacs? If Yes, Year & Body Style
1964 Cadillac Fleetwood Sixty Special
Cadillac LaSalle Club Member? If Yes, Membership #?
28645
1963/64 Cadillac Chapter Member?
yes

Christian Doerk's Photos

  • Add Photos
  • View All

Christian Doerk's Blog

correct size of vacuum hose turbo hydramatic

Posted on November 2, 2014 at 5:19pm 2 Comments

I'm pretty sure anybody here knows the correct size of inner diameter of the rubber vacuum hose from the metal vacuum line to the vacuum modulator assembly? Mine is the original one, too old and does have several cracks now. Now the gear is not shifting anymore or let's say at too high rpm.

I don't have my car around me currently. So unfortunately I can't have a look by myself! :(

Looking for a light blue (color code 33) 64' dash

Posted on February 21, 2014 at 4:20pm 2 Comments

A friend is looking for a new dash in good condition for his 1964 Series 62. His has several cracks and tears. It should be in the light blue color (code 33) if possible.

AC compressor ground wiring

Posted on February 18, 2014 at 6:24am 4 Comments

Hey guys,

hope you can help me one more.

I'm wondering how the correct wiring of the AC-compressor ground should be. If you do it like in the original shop manual on page 13-45 (Fig. 13-32, marked red), the compressor does not have any contact to the…

Continue

Where to get some new vacuum tubes?

Posted on May 16, 2013 at 9:01am 6 Comments

Some of my vacuum tubes are getting old and a bit brittle. Where can I get some new with the correct color-lines? Any tips?

Comment Wall (3 comments)

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

At 5:22pm on May 11, 2019, Tom Bahner said…

My email is tbbahner@aol.com. I can send pics better that way. I have 2 intakes off of 1963 caddy's. I believe 62 to 65 interchange. 

At 10:32am on March 19, 2014, Christian Doerk said…

Thank you Jason!

At 9:30am on March 19, 2014, Jason Edge said…

Welcome to the CLC. I will get you added to our Chapter Roster also.  ps...love the background and header here on your personal site. It's is a good reminder that everyone can personalize their page!  Everyone check out Christian's page by clicking on http://6364cadillac.ning.com/profile/Fleetwood60S

 
 
 

Photos

  • Add Photos
  • View All

Forum

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge yesterday. 1 Reply

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Bendix Power Brake Unit Power Section

Started by Mathis Richter in 1963/64 Cadillac Specific Discussion. Last reply by Chris Codd on Tuesday. 7 Replies

Hi,I have a huge problem my POWER SECTION of the ``Master-VAC Power Brake unit 9´´Diameter ´´ from Bendix is Broken and I can't open it to replace al the rubber parts did some of you have auch Power…Continue

Third brake light -help please.

Started by paul k in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Tuesday. 8 Replies

Did anybody from the club install third brake light in the rear window in his Cadillac? I have problem to figure out how to do it. Can I just run wire from break pedal switch and second wire connect…Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 6 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service