The often misunderstood 1963 Cadillac right front ashtray
I did a little tutorial on the 63 right front ashtray.I saw in Jason's latest video where he mentions this as a bad design. From my experience, it's not a bad mechanical design but rather it's not an intuitive, no-brainer design and there are no instructions in the owner's manual on how to close it properly. I hope this helps anyone who has problems closing that ashtray.
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
Excellent vid. They had to dumb the ash tray down in 64. BTW, love the T.A.
-
Permalink Reply by Kurt on
-
Thanks Russ. I love the TA too. I drove a 79 TA that I bought from my older brother when I was in high school. Had it for 13 years. Good times! It's my 2nd favorite car but it's a close race ; )
-
-
I was just out driving my '63 and when I was stopped at a red light I happened to look over it and think about all the people who have opened it but not been able to close it. Most of the time, I'd tell them "Don't worry about it. I'll get it later"
-
Permalink Reply by Jason Edge on
-
Fantastic Video! I Just added this to our Help Page under Ashtrays...
-
-
Thanks Jason. By the way, it occurred to me that although I have heard that the design was changed in 64, I have never opened a 64 right front astray. How does it open & close?
-
-
It's a simple S spring design. There is no "latching". See below. Not sure if you have seen all the Serviceman Bulletins devoted to the 63 ash tray regarding adjustments, and replacement parts. There were at least 3. I will have to find and post here sometime.
-
-
Push in at bottom to flip open, push in at top to close. Spring keeps enough tension to keep it in position either open or closed.
-
-
I just found this video of a 63 limo that was for sale. This guy could have benefited from my ashtray tutorial LOL. This is the typical 1st-timers experience with the 63 right front ashtray. The video will start at the good part.
-
-
Yep, he was fighting it!
Photos
Members
Forum
64’ A/C Power Servo - Vacuum Actuator
Started by Jacob Foster in 1963/64 Cadillac Specific Discussion. Last reply by Bernie Long Jan 1. 1 Reply 0 Likes
Gents, good morning!I’m looking for advice on how to fix the A/C Power Servo on my 1964 Cadillac Deville. The unit itself seems to be working correctly, but the vacuum actuator is leaking off. Has…Continue
CLASSIC CADILLAC PARTS CLOSED JAN 5-11, 2026
Started by Jason Edge in For Sale Jan 1. 0 Replies 0 Likes
Hello All,HAPPY NEW YEAR!Just a heads up that I will be in…Continue
NUTTY Fastener Trivia
Started by Jason Edge in Trivia Jan 1. 0 Replies 0 Likes
Ok. Here is a fastener I see about every day working with my big inventory of fasteners, and thought it was worth posting as trivia. If you saw my post on Facebook (I do sell them), wait to see if…Continue
2026 63 64 Cadillac calendars for sale.
Started by Russ Austin in General Discussion. Last reply by Russ Austin Dec 28, 2025. 2 Replies 0 Likes
The 2026 63 64 Cadillac wall calendars are out and for sale at 16.00 each plus shipping. Please email me at russ@thecadishack.com to get yours. …Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
-
January 18, 2025 - 63/64 Cadillac Chapter Zoom Meet-Up
January 18, 2026 from 7pm to 8:30pm – Zoom
0 Comments 0 Likes
© 2026 Created by Jason Edge.
Powered by
