The often misunderstood 1963 Cadillac right front ashtray
I did a little tutorial on the 63 right front ashtray.I saw in Jason's latest video where he mentions this as a bad design. From my experience, it's not a bad mechanical design but rather it's not an intuitive, no-brainer design and there are no instructions in the owner's manual on how to close it properly. I hope this helps anyone who has problems closing that ashtray.
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
Excellent vid. They had to dumb the ash tray down in 64. BTW, love the T.A.
-
Permalink Reply by Kurt on
-
Thanks Russ. I love the TA too. I drove a 79 TA that I bought from my older brother when I was in high school. Had it for 13 years. Good times! It's my 2nd favorite car but it's a close race ; )
-
-
I was just out driving my '63 and when I was stopped at a red light I happened to look over it and think about all the people who have opened it but not been able to close it. Most of the time, I'd tell them "Don't worry about it. I'll get it later"
-
Permalink Reply by Jason Edge on
-
Fantastic Video! I Just added this to our Help Page under Ashtrays...
-
-
Thanks Jason. By the way, it occurred to me that although I have heard that the design was changed in 64, I have never opened a 64 right front astray. How does it open & close?
-
-
It's a simple S spring design. There is no "latching". See below. Not sure if you have seen all the Serviceman Bulletins devoted to the 63 ash tray regarding adjustments, and replacement parts. There were at least 3. I will have to find and post here sometime.
-
-
Push in at bottom to flip open, push in at top to close. Spring keeps enough tension to keep it in position either open or closed.
-
-
I just found this video of a 63 limo that was for sale. This guy could have benefited from my ashtray tutorial LOL. This is the typical 1st-timers experience with the 63 right front ashtray. The video will start at the good part.
-
-
Yep, he was fighting it!
Members
Forum
1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly
Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin 2 hours ago. 1 Reply 0 Likes
Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering. Also, possibly looking for an oil filter housing assembly for a 1964 429 motor. Starting to get…Continue
A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 4 hours ago. 2 Replies 0 Likes
As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue
1963 AC evaporator core leaking?
Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kurt 15 hours ago. 1 Reply 0 Likes
Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue
Tags: 1963, core, evaporator, AC
Interior Ideas?
Started by Karl Schwarz in 1963/64 Cadillac Specific Discussion 16 hours ago. 0 Replies 0 Likes
I have a 1963 Series 62 convertible that I'm going to have the interior redone on. The car is Matador Red with a black interior. I'm looking to make the interior pop a little more than it does with…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 13 Comments 0 Likes
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
