What does this wire go to
I hv two open wires. My pictres dont pick them up in prior photos to were they went.
Its a yellow wire, it was coupled in the old fabrick casing with a green wire [runs to water thermostat sensor] and a black fabric coated wire. For some reason, when i tried starting, the yellow wire got hot and sort of fused with top of valve cover pan were a piece of the yellow coating had broken over time and contacted the valve cover metal.
Anyway, it has or had a use and wondering what it went to. It may have been to distributor before petronix change. If it has no use, i want to remove it ir clip it out of way of things
Replies to This Discussion
-
Permalink Reply by Kim K Kaiser on
-
-
-
The yellow wire should be connected to the starter solenoid and Ignition coil +, its hot 12v during cranking to provide full 12v to coil. The resistor wire provides reduced voltage to the coil during normal driving.
-
Permalink Reply by Jason Edge on
-
A description of the cranking system, including the wires and connections, is located in this Help Page topic:
-
-
Ok, think i got that all sorted out. Thanks for the help
Members
-
Kenneth Barton Online
-
-
-
Travis J. Hensley Online
-
-
Forum
Power steering fluid
Started by Bobby Brown in General Discussion. Last reply by Dennis P. DiBari 5 minutes ago. 6 Replies 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
1963 AC evaporator core leaking?
Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton 19 hours ago. 2 Replies 0 Likes
Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue
Tags: 1963, core, evaporator, AC
seat foam replacement
Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Kevin Robles yesterday. 3 Replies 0 Likes
does anyone out there have any experience with seat foam replacement on a 63/64 Cadillac. I had my seats reupolstered many years ago in original leather/fabric and they still look great, but the…Continue
1963 carter afb carbureter stainless steel shim
Started by tim sparks in General Discussion yesterday. 0 Replies 0 Likes
anybody have an xtra stainless steel shim for 1963 carter afb carb. thank youContinue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
-
July 20, 2024 - 63/64 Cadillac Chapter Zoom Meet-Up
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
Videos
© 2025 Created by Jason Edge.
Powered by
