Hey all,  the noise im lonking here comes and goes.  Its not normally at startup, kind of shows after abput 10 minutes  and most hearable at idle.  Last i was hraering it when it was really hot out, but it went away.  I believe the heat out was causing a vapor problem.  I took car out in hi 80s for abput 40 minute ride, got to desination.   Car never went over 1/3 on temp gauge, thought i was good,  Got out, went in for about 2o min and car wouldnt start.  Fuel in bowl was sbout an eighth high. Being 40 min from home, i panicked, got on internet searched vapor lock and found i could try and pour cold water on fuel pump, lines to try and drop temp.   After about ten minutes of pouring on pump and lines, it started!  Got home no prob.  Outsode temp had dropped to 70s.

The "noise" had not been around for a week or two,  then today, back again.  

Rrason i explained above was for recent driving for reference.

Here is the noise. It was dark out when i took it, seems more toward back of engine.  Any thoughts here

Thanks for listening


https://youtu.be/a8CsUlxv5IE

Facebook Facebook

Views: 619

Reply to This

Replies to This Discussion

Well i think i got it figured,  it was pointed out the notch on the end of shaft not pointed in right dirction. So had to flip it back, reset the arms, and result was oil flowing up and out of top of rocker arm, down the spine, onto springs,   the squuek was not present at all.

https://youtu.be/bv_I6hi4jDY

Thanks to all who helped me out.  Learn something new everytime i fiddle w this thing

Congrats on the fix. I had assumed rocker arm shaft assemblies were installed correctly...especially after all the discussion we had prior about following the shop manual (in pariticular rocker arm installation on section 13.8, page 9-17 in shop manual) and the fact they had to be installed correctly. I pretty much always get things wrong when I assume these days. Not sure how many miles were on the engine with rocker arm shaft on backwards but hopefully no damage done. Regardless, fire it up and go enjoy a ride in the Caddy!

RSS

Photos

  • Add Photos
  • View All

Forum

Logans Intake Project, 1964 Fleetwood, Progress Report #3

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb yesterday. 5 Replies

Not much of an Update and Questions: I was inspecting the top end and had removed the air cleaner in preparation to replace the intake. It was dirty so decided it needed a wipe down. My goof was…Continue

headlight / dimmer switch confusion (63 Sedan Deville)

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Wednesday. 4 Replies

The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue

Replacement Front Crankshaft Seal - 1964 Eldorado (429ci)

Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Wednesday. 2 Replies

My mechanic is having difficulty sourcing a front crankshaft seal.  Can anyone recommend a replacement front crankshaft seal, and where to purchase?  Amazon has a few that I think(?) are replacements…Continue

Tags: Seal, Crankshaft, Front

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service