Clock Repair
Dear Jason,
Thanks to your site, my clock from my 64 Cadillac is now in Wisconsin being repaired with Clock Works. Finally, I'll have a working clock after many years.
Dennis DiBari
Replies to This Discussion
-
Permalink Reply by Jason Edge on
-
I have been dealing with Clock Works for 20+ years now and always a good experience.
-
Permalink Reply by Dennis P. DiBari on
-
Hi Tim,
Just got the clock returned to me from Clock Works in Wisconsin. With the battery disconnected, I intend to install it tomorrow hooking up the light and power clip. It looks like new and they had it for about 2-3 weeks. Looks like a very reputable company. The install on my 64 should not take long. Thanks to Jason and our chapter for more invaluable resources.
-
Permalink Reply by Russ Austin on
-
Thats where I get my clocks rebuilt, you will have no problems.
-
-
Thank you for the feedback, Russ. It is much appreciated!
Dennis DiBari
Members
Forum
Welcome Returning Member Maurice Hamelick from the Netherlands!
Started by Jason Edge in Chapter Discussion. Last reply by Maurice Hamelink 22 hours ago. 2 Replies 1 Like
I wanted to give a shout out to returning Chapter Member Maurice Hamelick with his 1963 Four Window Sedan de Ville which was featured in our July 2016 Newsletter. Check out the newsletter via the…Continue
Rear suspension project
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 4 Replies 0 Likes
I have started my rear suspension project with the intent to replace bushings on the control links and yoke, shocks, coils and spherical joint. I have the car on jack stands and the transaxle…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Sunday. 3 Replies 0 Likes
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt May 20. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
