Convertible bumper jack
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?
Replies to This Discussion
-
Permalink Reply by Jason Edge on
-
There should be clips in each end inside the opening as seen in my picture below. If yours are missing I have plenty along with the screws that attach them.
-
Permalink Reply by Logan Robb on
-
Jason, are the wooden blocks a factory component? Mine also came with the black wood block for the tire block.
It is mega hot here this week. Perhaps repainting my bumper jack is something easy I can accomplish this week......
-
Permalink Reply by Alan Clark on
-
I believe all Cadillacs of the 60s and 70s came with those black-painted triangular blocks of pine. They did in my 67, 69, and 70 cars. I plan to take the dimensions off those and prepare a block for this 1964 car which is missing the block.
-
-
Did they come with one or two wedge blocks ?
-
-
One block in each of my cars - except the 64.
-
-
63's and 64's had one block.
-
-
Thatd be great! I think I have mine kicking around here somewhere. Let me know what the dimensions of yours is. I think mine was split in two it was so dry. Id like to remake mine as well.
-
-
Measurements of the block in the trunk of my 69 Cadillac:
Picture a right triangle:
Base = 3 1/2"
Height = 5 3/4"
Hypotenuse = 6 5/8"
The block is 3 1/2" thick, so if looking down on the base, you'd see a 3.5" square.
The block in my 67 Cadillac also is made of pine painted black, but the dimensions are a fraction of an inch different.
-
-
This is excellent! Thank you!
I shall remake mine as well
-
Permalink Reply by Kurt on
-
Thanks for this timely post. I forgot about the black wooden block that used to be in my trunk. Not sure where it is now. I recently finished a fence project & had a 6" scrap of 4X4 left over so I just made another with the dimensions you provided. I wish all my car projects were this easy.
-
-
It looks great, but the animated picture is spectacular. The talent in this group is impressive.
-
-
Thanks for the picture. I will investigate.
Photos
Members
Forum
Rear Main Seal Oil Leak Fix with Bearing Cap Modification
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Peter Lucas 5 hours ago. 26 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
64 A/C Time Delay Switch
Started by Jeff Donaldson in General Discussion. Last reply by Russ Austin yesterday. 1 Reply 0 Likes
Hi,I am looking for a replacement for my A/C time delay switch. If anyone has one I would like to buy it. I'm trying to repair what is left of my melted one. I foolishly took it apart without taking…Continue
63 CdV trunk lid issues with the mechanism
Started by Sammy in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Tuesday. 3 Replies 0 Likes
Hello folks,on a drive this weekend I had to open the trunk. Used the remote in the glovebox and it popped open a bit, but further opening was very hard und slow. I stood on the side of a main street…Continue
Take heads off for rebuild
Started by Ian Arnold in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Aug 2. 3 Replies 0 Likes
Compression test 15 years ago was good. Not a lot of miles since then. Summer car.Last year had a oil pressure issue. Found an aluminum flake had stuck open oil pressure relief valve. (Low pressure…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
New old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
Videos
© 2026 Created by Jason Edge.
Powered by
