The January 2015 Newsletter included a solution to replacing the Fender Skirt Seals often missing after 50+ years. I have attached as a separate PDF file which you can see by clicking on Fender Skirt Seal Replacement.
I will also copy this to our Help Topics page.
Tags:
I used a rubber seal that went over the skirt lip, its tight but seals really nice, I got it from rubber the right way. I like the way you should with the gasket material, I did not know that was the way it came originally.
The rubber seals they seem to carry would be a good substitute. The original seal is usually long gone. The pictures at the start of the article that I included, were of the 41K mile Fleetwood that had been in a garage since the late 80's. Even it was coming off as you see.
Started by Michael Monson in Wanted to Buy. Last reply by Michael Monson 7 hours ago. 2 Replies 0 Likes
Looking for a heater control valve 9.795 for my 1964 Deville. ThanksContinue
Started by Jeff Donaldson in General Discussion. Last reply by Logan Robb yesterday. 4 Replies 0 Likes
Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue
Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Sunday. 7 Replies 1 Like
Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light? Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue
Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin Feb 18. 1 Reply 0 Likes
Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2026 Created by Jason Edge.
Powered by