Need window switch for 1964 Deville convertible
Of course just the drivers window doesn't work

Views: 165

Reply to This

Replies to This Discussion

Hi Phil, you can often pull the case off the switch body, cleans the contacts and bend tabs up a bit and get working again. Might give that a try if not already done.

the bottom of the switch is broken off and the wires no longer are held in--if is jump the wire out the window goes up and down--been this way for a while finally just quit working

Also check for broken wires inside the door jamb wire conduit.

all the wires have been repaired--99 percent sure its the switch

Maybe I could use a new drivers wiring harness for the window instead. Anyone have one

Phil, the drivers door is always the worst for wear. I have yet to bring in a car with all the wires intact. American Auto Wire builds new wire harness's. You just send them your old one.

I believe I just need the plug at the end where the master switch connects mine fell apart if you have the plug with 6" of wire that would be perfect also the drivers window switch is the only one that is inoperable the other windows all work from the master switch

Phil, I have a plug.  Send me an email to;  russ85747@hotmaiil.com

RSS

Photos

  • Add Photos
  • View All

Forum

Ordering Polyurethane Replacement Trailing Arm Bushings

Started by Dan McNarry in 1963/64 Cadillac Specific Discussion. Last reply by Dan McNarry 4 hours ago. 4 Replies

There seems to be growing interest in the poly bushings. In order for me to keep track of who wants bushings, please send me a message along with or in lieu of a reply to either this thread or the…Continue

What gasket or seal at the PCV pipe under intake?

Started by Tosh Dickenson in General Discussion. Last reply by Russ Austin 11 hours ago. 3 Replies

Wonder what kind of seal goes on the metal PCV pipe under the intake?  It looks like the larger part is kind of a press fit into the manifold but maybe there was a rubber gasket under the bolt that…Continue

1964 Interior AC/Heater Box Removal

Started by Travis in Restoration Discussion. Last reply by Travis 21 hours ago. 13 Replies

Newby question here!  I've read through the shop manual and as many threads as I could find on here, but I'm still stumped on exactly how to remove the interior plastic Heater/AC box from my 64 SDV…Continue

Tags: vacuum, mode, door, box, a/c

Drain plug and speedo bullet seal.

Started by Pete Grodem in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin yesterday. 3 Replies

Hello,Sealing  up my 63 Jetaway duel coupling and questioning the drain plug and the speedo bullet, both used an o ring for sealing. This does not seam proper as the o ring gets crushed when…Continue

Blog Posts

How to sensibly deal with the Corona Virus

Posted by Jeff Kinzler on March 14, 2020 at 5:02pm 6 Comments

https://theamericanscholar.org/covid-19-a-primer/

I found this very helpful, written by a knowledgeable authority in public health. 

Remember, Viruses are not spread by Cadillacs so get out and drive!


Safe & Healthy travels. 

Jeff Kinzler

1963 Eldorado convertible boot

Posted by Les Eastling on February 27, 2020 at 10:33am 1 Comment

I need a used convertible boot for a 63 Cadillac convertible - condition or color is not an issue since it will be used as a pattern for making a new one. One from either a 62 series convertible or an Eldorado would work. I know I am searching for hen's teeth here... but you never know unless you ask!

Looking for 63 Convertible / Coupe rear side trim

Posted by Gene McIlroy on January 24, 2020 at 12:18pm 0 Comments

Want to find a good straight dent free rear side trim for my 1963 Convertible.  I have both sides but they do not match.  Wanting to get them to match.  I am attaching a photo of the two trim sided that I have really wanting the squared off trim if I can get it.  Let's see what you have,…

Continue

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service