I was considering adding this petronics system to the 63 model.....
advantages //// disadvantages?
keep in mind, i am complete novice,,
Sincerely
Kim
Tags:
Don't have to adjust points. If installing a new coil as well you will get higher voltage = better spark.
Read these three links and you should be good to go:
Pertronix Ignitor Ignition & Flamethrower I, II, and III Compar...
Petronix 3 Kim - just remember you need to rewire in full 12 volts for the petronix ignition itself (inside the dizzy) and the coil but you pick that up off the battery and use the ignition voltage signal to switch the relay. With the 64 429s its pretty easy with the dizzy at the front. I did one for a friend with a 59 and it was a pain getting to the dizzy at the back of the engine = you have to stand inside the engine bay to reach down inside and wire it all in! overall though a great ignition system!
John
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 1 hour ago. 1 Reply 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari on Saturday. 3 Replies 0 Likes
for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies 0 Likes
Is anyone here planning on going to the Back to the 50’s car show in Minnesota?
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by