Rear main bearing seal
Hello everyone
can anybody advise me where I can get the main bearing set with the double groove in it to fix the rear seal leak as I have read about it in the help section.I am located in Kadina South Australia and dont want to order the wrong part as Freight is quite expensive at the moment
your help would be greatly appreciated
Regards
Phil From Down Under
Replies to This Discussion
-
Permalink Reply by Phillip Hill on
-
Thanks I will get onto it
Members
Forum
Dino Radiator Leak - Time to Recore!
Started by Jason Edge in General Discussion. Last reply by Jason Edge 9 hours ago. 35 Replies 0 Likes
I had brought up the topic of radiator leaks as a discussion topic for our Chapter Zoom meet-up this past Sunday and thought I would share on our website for everyone and probably do a more formal…Continue
1963 390 upper heater core hose
Started by Kenneth M Karrer in General Discussion. Last reply by Bill Wolf 11 hours ago. 5 Replies 0 Likes
Hello, My 63 convertible is a low mileage (34k) original car so while I've done some basics, like replacing radiator hoses, belts, and a few gaskets; I've been trying to leave things as is as…Continue
Replace Choke Tube or Install Electric Choke?
Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 13 hours ago. 3 Replies 1 Like
My mechanic has sourced a choke housing and new internals. As you might expect, the choke tube is damaged and or clogged. My options are to either replace the choke tube, or my mechanic recommends…Continue
Tags: Electric Choke, Choke Tube
lighted headlight switch
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Michael Stinson 14 hours ago. 3 Replies 2 Likes
I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
