Here are pictures of the rear seat belts from a 1964 Sedan de Ville equipped with front and rear seat belts. Trim Code is 43, which translates to light blue. This will be linked to from our Help Page.
Comment
I have linked to this photo album from our Help Page.
Started by Norman Silverman in 1963/64 Cadillac Specific Discussion 18 hours ago. 0 Replies 0 Likes
I am considering replacing the shocks in my 64 SDV. They're not terrible, but are a little too wishy-washy. I want to replace them with shocks that most closely approximate the original damping rate…Continue
Started by Jason Edge in General Discussion yesterday. 0 Replies 0 Likes
While scooting around under my 64 CDV Dino I am seeing a lot of thinks to address, including swapping in a lot of my gold cadmium plated hardware. Since I am headed to the cad platers in…Continue
Started by Richard Stanley in Restoration Discussion. Last reply by Jason Edge yesterday. 1 Reply 0 Likes
Recently, I discovered that the kick down switch was frozen on my '64 Eldo due to a rusty plunger shaft. Rubber boot seals seem to be unavailable. I bought a refurbished one and swapped it out. …Continue
Tags: electrical, short, ignition, transmission, carburetor
Started by Jason Edge in General Discussion yesterday. 0 Replies 0 Likes
The last parts car I brought in was a true east coast rust bucket, but with 60K miles it had some fantastic parts, some of which I am still adding to Dino, my 64 Coupe de Ville.The "Yaw" front side…Continue
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 1 Like
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
February 23, 2025 from 7pm to 8:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website