Started this discussion. Last reply by Logan Robb Jun 4. 4 Replies 2 Likes
I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue
Started this discussion. Last reply by Kurt May 20. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Started this discussion. Last reply by Bill Wolf May 7. 4 Replies 0 Likes
The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue
Many thanks Bill
-Samu
Bill, The ashtray link pulled up a post by Chapter Member Kurt Edmiston with a link to his video. The link worked for me. Here is a direct link: Click Here. The other links were posted by members that are not longer in the Chapter. When they were removed the posts were removed. I will make a note that we need to add them back.
Thanks Bill
Yes mine does have a/c
As far as having to pour fuel down the carb to get it started. Have you checked the fuel filter, maybe replace it. If that is good the next thing to check to see if the fuel pump is working. If all of is good the next thing is look into the carburetor.
Welcome to the 63/64 Cadillac Website.
This site is hosted by the CLC (Cadillac LaSalle Club) 1963/64 Cadillac Chapter. Joining the website is free to everyone, however, you must be a CLC member to join the Chapter.
- Click on www.join.6364cadillac.com for more information on joining the 1963/64 Cadillac Chapter and the Cadillac LaSalle Club.
Be sure and check out all the links and pages and make yourself at home. The Help Page at www.help.6364cadillac.com will have links to many useful articles and information about our Cadillacs.
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 5 Replies 0 Likes
While enjoying the fruits of my labor on all new rear suspension and…Continue
Started by Rick Yasenchack in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
I bought my 63 2-door convertible 62 series a few years back, previous owner said a new brake booster was just installed and that was why brake pedal was a rock. Did not know.Just had engine…Continue
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Tuesday. 2 Replies 0 Likes
I'm looking for some info and hopefully some pictures on the commercial chassis dual battery setup. Is the second battery tray (driver side) , the same as the passenger side or is it mirrored? I'm…Continue
Started by Jason Edge in Chapter Discussion on Tuesday. 0 Replies 0 Likes
Chapter member Alan Clark and owner of a 1964 Eldorado sent this and wanted to share with everyone in case there are others nearby that might want to attend:"I'd like to invite the 63/64 chapter…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by