I haven been able to check for the starter items until today,  so i went out and noticed a lot of fluids on the ground that had run down towards the front of the car as it was on a slope.  so i looked quickly and could see active dripping,, touched it, and it was gas!!!

i opens the hood, and up around the carb, i noticed a puddle of gas ( see picture attached)  i had seen this the other night when i was trying to figure out the starter thing and just figured it was from where i had pour some gas in carb to help start and figured it was run off or i had missed some.  so i absorbed it, cleaned it up dry.  noticed the accelerator pump was a little damp dried it too, and left car as it seemed the starter or straps had been problem,,   so i was surprised to see all the gas and fluid underneath,,, i checked the fuel filter and it was dry as well as the hoses.,  it looks like, but cant be sure, the highest point is the accelerator pump,, now would that continually leak for 4 days with out the engine running  to create this kind of leaking ?  what would be my procedure from here for diagnosis and repair,  if you can tell from the pictures.  that little pool is about an inch deep below he carburetor.. so it holding a fair amount of fuel,,guessing about as big as a thumb,, and the squiggly marks on the accelartore pump are gas and liquid below the rubber boot

thanks,,

Facebook Facebook

Views: 597

Attachments:

Reply to This

Replies to This Discussion

i am adding this since i was fooling around the carburetor, this particular hose seems very loose,, it kind of just popped loose when i was trying to dry out the gas source.  should it be that loose or should a clamp be on this,,you can see that its a bit off and not snug up on the metal piece,  its out of the front of the carburetor on the bottom

Attachments:

I'm not able to open your pictures. (I'm not sure if its the site or my computer.)

No disrespect Kim, but I think its time to get a mobile mechanic to come around and take a look as I think you're getting in too deep now. I'm sure if one of us was nearby, we'd be around in a flash to help you.... I know I would.

yes,, may well be,,no offense taken, i realize my limitations.  

 i will note that i did find that big strap from the frame to the starter, it was completely covered up by gunk and goo.  i suspect from when the radiator was leaking profusely and the fluids were blowing back under the engine.  

Its for your pcv valve. It should have a tight fit and is secured by clamps originally. The pcv valve is the metal thingy these two hoses are attached to.

i dont under stand why the pictures dont come up,, i get them on mine, but will try again 

Attachments:

I did see the original pictures. Might just have been the site behaving bad.

When you post pictures its easier for the reader (us) if the picture is inserted in the post rather than being an attachment.

It is the same procedure as "Uploading Files", except its the "image" button marked in red. Try it next time and you see what happens. Glad you are using pictures as it is a lot easier to see with own eyes than reading a text.

this is free standing gas below the accelerator pump shaft

See my comment on first page for the pcv valve

RSS

Photos

  • Add Photos
  • View All

Forum

Swapping 429 engine crankshafts

Started by Jacob Foster in 1963/64 Cadillac Specific Discussion. Last reply by Jacob Foster 9 hours ago. 4 Replies

Hello All! I’m struggling to find an answer to this question, hoping a member can help. Can I swap the crankshaft from a 1966 429 w/TH400 to my 1964 429 w/TH400 trans? I came across an article that…Continue

1963/64 Cadillac Chapter July 2025 Newsletter Posted

Started by Jason Edge in Newsletters. Last reply by Dennis P. DiBari 12 hours ago. 1 Reply

I have just completed and posted the July 2025, 1963/64 Cadillac Chapter Newsletter to our…Continue

Tags: Chapter, Newsletter, Posted, Cadillac, 1964

1963 AC evaporator core leaking?

Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton yesterday. 4 Replies

Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue

Tags: 1963, core, evaporator, AC

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Tony Prichard yesterday. 4 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service