I'm using a bunch of different sources to try to build a fairly complete single wiring diagram for my 1963 Series 62 convertible. I've got a couple of questions:
1. Does anyone know what the circuit circled in red on the attached image does? Near the bottom of the marked area it seems to have a switch between the white wire and black grounded wire, but I have not been able to find this circuit leg in any other diagrams I've looked at.
2. If the car has AC, does the typical AC wring replace the non-AC blow/heater wiring? I assume cars with AC have only one blower motor. Can anyone confirm?
Once I get done, I'll share the work with this group. I know about (and have) some of the other color diagrams. I am building my own not just to get me the picture I want, but also because it helps me better understand how the car is wired. Fortunately, the wiring in my car seems to be in decent shape.
Tags:
It appears to be the door activated switch circuit for courtesy lamps.
Thanks for the replies.
Dan, that was what I thought at first too, but the diagram has front and rear door switches located elsewhere. However, your idea leads me to a question. Is there a switch inside the car to turn on the courtesy lights (perhaps on a ceiling light on a hardtop car)?. I have a convertible, so I suspect such a switch might exist, but not on a convertible.
Travis J. Hensley Online
Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Kevin Robles 17 hours ago. 3 Replies 0 Likes
does anyone out there have any experience with seat foam replacement on a 63/64 Cadillac. I had my seats reupolstered many years ago in original leather/fabric and they still look great, but the…Continue
Started by tim sparks in General Discussion 23 hours ago. 0 Replies 0 Likes
anybody have an xtra stainless steel shim for 1963 carter afb carb. thank youContinue
Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 1 Reply 0 Likes
Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark yesterday. 13 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by