Transmission vacuum modulator
Today I started to exchange all old vacuum hoses under the hood.
The one going to the transmission vacuum modulator is really hardened out, but I can't get that thing out.
Is it screwed or pushed in?
Didn't want to disassemble the whole bracket.
Maybe it is a good idea to exchange the whole thing, but where can I find it?
- Attachments:
-
-
DSC_0272.JPG, 2.8 MB
-
Replies to This Discussion
-
Permalink Reply by Sammy on
-
Found it in the shop manual.
I am still wondering what this is for...
And where to get replacement.
-
-
No I have a 63 with the Jetaway.
So no vacuum lines to that transmission?
-
Permalink Reply by Jason Edge on
-
The part in the picture that the vacuum line hooks up to is the Throttle Check Valve. It has nothing to do with the transmission. When you suddenly let off the gas, it slows down the movement of the throttle rod to carb to prevent the engine from stalling. It is referenced several times in your 1963 Shop Manual and adjustment procedures are in section 26.f page 10-33. If you apply vacuum with a vacuum pump it will start to retract the plunger until it is all the way in. Then it should hold vacuum. If it leaks down it should be replaced. It has been my experience these are pretty rugged and hold up quite well compared to some of the other vacuum actuators. If your is leaking down I have them for $25 + s/h. Email me at jasonedge@nc.rr.com.
-
-
Got it.
Problem is that I can't get it out *lol*
The hose on it is so hard I have to cut it, but can't get beneath.
I'll try some more.
-
-
There is a retainer clip that hold the diaphragm to bracket. Pull it out with a needle nose. Heat the hose up a bit on low setting with a heat gun. If it is that hard if you take pliers just squeeze the rubber at the nipple and it should break apart. Many ways to skin that cat.
Members
Forum
Rear Main Seal Oil Leak Fix with Bearing Cap Modification
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal 20 hours ago. 16 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Coolant Overflow Bottle / Reservoir for 64 Cadillac Eldorado
Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf yesterday. 9 Replies 0 Likes
Greetings Everyone. I read a discussion thread about "radiator and related", covering coolant overflow. Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac? Is there if a…Continue
1963 Eldorado Trim complete set
Started by Robert Dye in For Sale yesterday. 0 Replies 0 Likes
This is complete set of nice 63 Eldorado trim. Would like to sell as complete set but have duplicates of most of the moldings that can be sold separately. I am attaching a few pictures but you can…Continue
Convertible bumper jack
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark on Monday. 4 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
