Pulling in Parts Car #54
Back to the hotel in Hickory NC with parts car #54 - a 1964 Series 62 Four Window Sedan. Lots of goodies on this beauty! Headed home with our prize tomorrow.
Replies to This Discussion
-
Permalink Reply by Wayne Morris on
-
I have found one so I no longer need one, thanks
-
Permalink Reply by Jason Edge on
-
Wayne, that is good news. I have removed from my Wait List. Jason.
-
Permalink Reply by Jeff Donaldson on
-
Hi Jason,
How are the tail light ecsutcheons on your new parts car? If they are there and in pretty good condition I'm interested. Please let me know.
Cheers
Jeff
-
-
Hi Jeff, I have 3 customers on my Wait List for 63 Tail Lamp Escutcheons. Email me or post here your contact info and I also put you on the list and get back with you when I have something available.
When I bring a parts car in and start breaking it down I go down my Wait List so for these or anything else you need email me at jasonedge64@outlook.com.Jason.
- ‹ Previous
- 1
- 2
- Next ›
Members
-
-
-
Travis J. Hensley Online
Forum
seat foam replacement
Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Kevin Robles 1 hour ago. 3 Replies 0 Likes
does anyone out there have any experience with seat foam replacement on a 63/64 Cadillac. I had my seats reupolstered many years ago in original leather/fabric and they still look great, but the…Continue
1963 carter afb carbureter stainless steel shim
Started by tim sparks in General Discussion 8 hours ago. 0 Replies 0 Likes
anybody have an xtra stainless steel shim for 1963 carter afb carb. thank youContinue
Timing cover corrosion
Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 15 hours ago. 1 Reply 0 Likes
Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue
Convertible bumper jack
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 23 hours ago. 13 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
-
July 20, 2024 - 63/64 Cadillac Chapter Zoom Meet-Up
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
Videos
© 2025 Created by Jason Edge.
Powered by
