I have noticed that after I drive for 5-10 miles or more and then shut off the car, it hesitates when I go to start? Anyone experience this before and if so, what was the fix?

Facebook Facebook

Views: 388

Reply to This

Replies to This Discussion

Alternators will only produce what is required, and as I recall most alternators actually only produce up to about 2/3's the rated amperage under normal rpm/driving anyway. So with that 55 amp factory alternator it might be producing say up to 30 amps max at any moment under extreme max current draw load.   This is why the factor 10 gauge alternator to battery (secondary charging) wire is sufficient ... but one reason why I wanted to move away from the considerably smaller 14 gauge Heartbeat City sources wires reproduced for the 1969 Camaro, and get M&H to produce wires with the correct factory 10 gauge. (I guess even back then, the Cadillacs were pulling much more power than the average Camaro or Mustang). 

So, with that 100 amp alternator, unless you are installing a Giga-Splat-Velocity-Blaster in the trunk that draws 50+ amps you are  probably never going to draw (ie. the alternator produce) anywhere near 100 amps.  If you have the mega-amp-mega-power-draw sound system (that rivals the soundstage at an AC/DC concert), then you might want to get M&H to fabricate a cable with a thicker alternator wire (8 ga, 6 ga, 4 ga, etc).  

Latest update! Had alt rebuilt to 55A and installed tonight. Took a few minutes to start after sitting 6 weeks and no GEN light on while running! As you can see from the pic, fixed my over charging while running! Now for the new battery cables. 

Great work Dave.  It's great when GEN light goes out and it's not overcharging.  I remember going through that last year.  

Dennis DiBari

Dave, That is great news. If your car is wired correctly, removing the battery cable while running is a quick & easy way to find out if the alternator is working. I actually just ordered a couple of rebuilt alternators through AutoZone today as I had a $45 reward to use, and like to keep a couple of them ready to go on the shelf.

RSS

Photos

  • Add Photos
  • View All

Forum

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Tony Prichard 5 hours ago. 4 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Power steering fluid

Started by Bobby Brown in General Discussion. Last reply by Tony Prichard 5 hours ago. 7 Replies

My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue

1963 AC evaporator core leaking?

Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton yesterday. 2 Replies

Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue

Tags: 1963, core, evaporator, AC

seat foam replacement

Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Kevin Robles on Wednesday. 3 Replies

does anyone out there have any experience with seat foam replacement on  a 63/64 Cadillac.  I had my seats reupolstered  many years ago in original leather/fabric and they still look great, but the…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service