Just to share a few things:

- We will have our next Zoom meet-up this Sunday, Feb 23 at 7pm. I will send a notice out tomorrow with the link then again Sunday. If you cannot make it that is fine, just show up as you can.  I will try to hopefully get back to a monthly schedule after missing January. 

- I have surgery March 4 on my left elbow and wrist for Cubital Tunnel Syndrome (Carpels Evil Cousin), and have to say I am an absolute 100% true lefty, so many things including typing will be a challenge. It is a challenge now as my left hand feels dead on the left side without much feeling but hopefully surgery and several weeks of recovery will fix that. It has made typing a lot painful and difficult not to mention backing up and correcting my typing over and over! Argh.

- I hope to have the newsletter done before surgery... but we will see. 

- I am  trying to get a lot of physical stuff done before I have surgery and will go pick up my next batch of Cadmium plate fasteners and Parts this Monday, Feb 24. I figured if nothing else I can sort bolts with my right hand!  I have also been trying to complete some yard projects including widening my white rock driveway which requires a lot of digging and moving dirt! I am getting there.

- Dino has been perched up in the 12" Race Ramps and I have started getting up under it more and cleaning, painting, and replacing some cadmium plated items. I will start posting pictures again of some of the upgrades. 

- I will shut up for now, but will encourage everyone to use this site and post your questions, pictures, etc.  I always like to read and see what you are all up to!

Jason. 

Facebook Facebook

Views: 31

Reply to This

Replies to This Discussion

Hey Jason I know how you feel as Ive been glazier for the past 40 years my hands and shoulders are worn out and I suffer the same as you.I wish you all the best with your surgery 

Hi Jason,

     Good luck with your surgery on March 4th.  I hope it is a quick recovery for you.  All the best.

Dennis DiBari

RSS

Photos

  • Add Photos
  • View All

Forum

Wanted Cadillac Lasalle 2 inch Windshield Decal Sticker

Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari yesterday. 3 Replies

for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service