i read a long thread on the sputtering when turned off her back from a few years ago,,, and today for the first time, mine did it 63 CDV.. i drove it once to day for a about 10 miles and had no issue,, yesterday,, same,, and couple days prior,, same. it is hot as blazes here in MT today, 20 degrees cooler last few days,, anyway, i was just running the engine to check oil and some other things, and when i went to shut it off, it kept on,
now, in that prior thread,, i saw testing compression,, How is that done and with what tools..
flushing the system engine/system. how is that done, and what tools?
i saw turning the distributor to set points,,timing, etc,, should i watch a you tube video on the basics of this stuff,, on an older car, so that i dont bog up a lot of bandwidth w basic questions..and then turn to here for cadillac specifics..if i can see it done, and have some instructions, i can do lots of things, but i have to know why and see it done..
so what suggestion would you offer 1,, the sputtering,,
secondly,,learning sources,,
basic engine history i should note, the engine rebuilt at i think 100k,, actual miles 143,, transmission not long after that, so it has had work done to the engine in prior owner, i have the receipt for both and both were in the thousands of dollars back in 90s, assuming it was pretty complete due time value of money, and also, prior owner mentioned some hard rings or seats??? for fuel accommodation, so over about 10-12 years,, 40k miles have been put on since.
sorry for the multiple questions,,, i just need to know where to get basic visual nfo,, and i can learn from there...but short of you tube, are there other places
Tags:
no,, saw one at the parts store, but held off the purchase as wasnt sure which to get,, wanted to do some reading on it,,heading to bozeman tomorrow,, was gonna pick up one, suggestions??
Get the timing light and check the timing. Follow the shop manual.
no, was running to warm to check power steering per manual,, and on to check transmission, i just had it on, listening to things,,
Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari 19 hours ago. 3 Replies 0 Likes
for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies 0 Likes
Is anyone here planning on going to the Back to the 50’s car show in Minnesota?
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Sunday. 2 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
June 22, 2025 from 8pm to 9:30pm – Zoom
0 Comments 1 Like
© 2025 Created by Jason Edge.
Powered by