Ok, short refresher, last dec i relpaced starter w rebuilt from usa parts. and even then, after short runs where i got up to temp, if i shutvcar off, and then tried to start, it would drag heavily a d would not start. 10 min later, it would start fine. At the time, i hv cleaned all grounds, all grounds properly, i wrapped wires withe the heat tape, moved them back from exh manifold, things seemed ok.
Last cupla weeks, same symptom, short rides around town, no problems, always starts, longer rides, if i get gas, car barely starts, sometimes, it doesnt even click, i can just hear a humm, after a time or two. , it will slow turn, then start.
So i got bk under car, notced the black wire had a crack anf i coukd see copper. As a temp fix, i put electric tape on it, applied the heat tape, took out for long ride tonight, 45 min or so at 70, [no vibrations from rear, yeah!!]
Anyway, i got out, got in, no start.
So what testing should i do now, should i try to rewire from ignition key to solenpoid/starter, replace solenoid, what further test can i run that i didnt try in dec. my limited knowledge says heat has something to do with this, sustained heat, not just 2 minutes cross town, but longer rides.other than this recurring headache, car doing good
Tags:
Tony you ARE our resident cheerleader, all you need is a set of pompoms and a short skirt to complete the picture .
Jason, I will not ask if those are yours.
cold. 12.6 to 12.8.
Started, was running at 14.67.
Took for 30 min ride, headlights on high, turned off, took volage. It was 12.4, then i realiaed i had not shut off headlights, i then shut them off, and i got bk to 12.68, 69. So i am guessing alternator is functioning as it should?
However, the most encouraging part was after the ride, i cranked car immediate after the battery test, and it fired right up, none of the slow clunk clunk sound. Or clic click as i normally woukd get after that kind if ride, so. Im encouraged that maybe the battery was just not powerful enough. Not gonna say cured, but encouraged, need a good hour to see what happens
Kim, is this testing a new battery or the battery you had when this was posted September 9, 2018 at 9:26pm? I tried to go back thru the post to see where you had installed a newer higher CCA battery and do not see the posts.
I did find a post from yesterday where you stated "Napa shop here has a 850 cca that will fit my tray." So, did you buy it? Did you install it? Is this what you are testing? Again, sorry if I missed the post where you had bought and installed a newer battery with more CCA.
For whatever battery you are testing the voltage specs are good.
Sounds like you are good to go.
Yep, and of course for sale. Actually have quite a few of them!
Yes, its the new battery i bought today, 9/21. The 850 wouldnt fit tray. Had to get an 810 or 820. The engine turnover was signifucantly more powerful after the 30 minute ride. Usually , i get about 3 slow roll overs, and then a start, this was quick and strong.
I'm just a guilty as the next guy, but this goes to show that checking the basics first will help in troubleshooting.
I always gravitate towards some obscure reason as to why something is not working, but checking the basics first help rule out a lot of wasted time and money.
Agree. Agree and Agree! And will even add to check the Easy Basics 1st. When you pop the hood the Battery (cranking) and alternator (charging the battery) are right in front of you when you pop the hood!
The problem for me though, is i bout a new battery less than year ago, based on asking parts store, do you hv a battery for a 63 deville. I assume its rated to what it needs, so y question. Same as one of tge brake cylinders i bought, new product, hours of chasing hot brakes, then find out, new cylinder was bad! Lots of hours burned over new product. While working the battery apparently isnt truly a functional match, but does fit the tray. Maybe thats what they base, "it fits your car". Anyway, i am taking on a full on hour plus ride, and once there, will see if it still turns over good.
Thanks for all the help!
I could go on and on about the quality of new parts being sold. For my kids 93 deville, a new radiator, ac compressor, distributor, fuel pump, and others all had to be replaced twice due to defective new parts.
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson 2 hours ago. 5 Replies 0 Likes
Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion 4 hours ago. 0 Replies 0 Likes
Hello all!Just a short update this evening!I wrestled with the exhaust manifold studs and ultimately chickened out on replacing all 4 of the studs. I only replaced the stud that I spun the threads…Continue
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 8 hours ago. 1 Reply 0 Likes
Cheryl brought my 4 1/2 month old boy Scout out to the garage in a man-bun to help work on the Cadillac. Sometimes you just have to roll with it! (I am scared to see who she will "dress up" Bandit…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb 16 hours ago. 5 Replies 0 Likes
I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2025 Created by Jason Edge.
Powered by