Classic Cadillac Office - A True Self-Starter!!
I spend a lot of time up in my office and have gradually been transforming it into a Classic Cadillac Office! Here is where I run Classic Cadillac Parts, Direct the CLC 1963/64 Cadillac Chapter, and Hold down the Fort! I have a long way to go, but thought I would share my Wall of Self-Starters that runs down one 32 foot wall of my office. Thanks to CLC President Lars Kneller, and Carolina Region Director Travis Dowell, for contributing to my Cadillac Obsession. I now have every Cadillac & LaSalle Club Self-Starter from Feb 1961 forward, and hope to fill the 1959/60 gap at some point! Anyway, Here is a peak into my Cadillac Office.
I have posted 3 pictures here but have more posted on my Facebook page which you can see by Clicking Here.
Replies to This Discussion
-
Permalink Reply by 2o93f8rdftyzj on
-
Very tidy Jason..... almost too tidy. No OCD in your family. LOL
Hmmm, I can just picture a visiting Aussie messing that up during a visit in.... oh... I dunno..... maybe around 5 months time :-)
-
-
Nice office Jason, your definitely a Cadillac guy.
-
Permalink Reply by Jason Edge on
-
It is a work in progress. Just really getting started but since I have most of my Self-Starter's in place thought I would show you guys down at least one wall. Big changes coming next when I start moving my tall book shelves off the raised center desk "Control Center" to the back wall!
-
-
A Cadillac Crazy following a Cadillac Crazy following a Cadillac Crazy! Doesn't sound too Crazy to Me!
Your Cadillac Crazy!
Members
Forum
Welcome Returning Member Maurice Hamelick from the Netherlands!
Started by Jason Edge in Chapter Discussion. Last reply by Maurice Hamelink yesterday. 2 Replies 1 Like
I wanted to give a shout out to returning Chapter Member Maurice Hamelick with his 1963 Four Window Sedan de Ville which was featured in our July 2016 Newsletter. Check out the newsletter via the…Continue
Rear suspension project
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 4 Replies 0 Likes
I have started my rear suspension project with the intent to replace bushings on the control links and yoke, shocks, coils and spherical joint. I have the car on jack stands and the transaxle…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Sunday. 3 Replies 0 Likes
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt May 20. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
