Hi Jason,

     I am looking to purchase a front fender splash guard bracket for my 1964 Series 62 - passenger side.  I saw your post from a few years back with the picture you posted.  Anywhere I can get this part?

Dennis DiBari, Cottekill, NY

Views: 57

Reply to This

Replies to This Discussion

Is this the front lower bumper end splash apron bracket that is behind the splash apron seen below?  It runs diagonally across the front lower bumper end and has one splash apron attachment point in center for bottom section of the splash apron.
If so, let me know left or right?   If not, let me know which splash apron with a picture or more descripion.

Hi Jason,

     THANK YOU for sending me the picture of the apron.  That is the exact bracket you described and it is for the passenger side of my 1964 Series 62.  If you have any leads it would be most appreciated!  Thank you again.  Dennis DiBari

I checked and have one right side that has some corrosion but solid enough to support the masticated rubber splash apron.  You could also use it as a template to make a better one out of a piece of new steel. 

Price is $10 ($7.50 with Chapter Discount). If you need cadmium plated original 2 bolts and 2 nuts to secure to lower bumper end add $5.  I can ship for $10 for a total of $17.50 (bracket only) or $22.50 bracket and fasteners.

Hi Jason,

     I want to thank you for researching this for me and I would like to purchase the bracket and fasteners for the $20.50.  Please let me know the payment arrangements and I'll provide you with this immediately!  Thanks for looking into this.  I know you have been on the road the past few weeks!

Dennis DiBari

Dennis, Send PayPal to email jasonedge64@outlook.com. If you don't have PayPal I can send you an invoice so you can pay with credit or debit card.
Jason

Hi Jason,

     I don't have Pay Pal, so if you can send an invoice, I can pay with credit card or check for the items.  I'll send you an email with some information if that helps.

Thank You, Dennis

Jason,

     Thank you for helping me acquire this part for my 64 - Series 62.  I really appreciate it!

Dennis DiBari

RSS

Photos

  • Add Photos
  • View All

Forum

windshield wiper/washer issue

Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 40 minutes ago. 2 Replies

I have a 64 Cadillac Deville convertible. When the wiper switch is turned on the washer pump activates continuosly no mater what speed is selected. Washer pump shuts off when wiper switch shut off.…Continue

63 De Ville trans dip stick tube

Started by Scott Santora in Wanted to Buy. Last reply by Russ Austin 42 minutes ago. 1 Reply

I'm looking for the transmission dipstick tube for a 63 DeVille.  Continue

cornering lights

Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 8 hours ago. 16 Replies

Neither of my cornering lights are working. I started by focusing on drivers side. I removed the entire assembly and cleaned it up, replaced the wire to the socket, cleaned and lubricated the socket…Continue

Cadmium Plated Cadillac Bolts - More Used that You Can Shake a Dip Stick At!

Started by Jason Edge in General Discussion yesterday. 0 Replies

I have now had just under 3,500 lb of Cadillac fasteners gold cadmium plated, one thing I don't run out of or have to run down to the hardware store are nuts and bolts.  I just replaced my 20+ year…Continue

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service