Oil Filler Cap Reproduction and Restoration
I have saved the June Tech Tips article Those Dang Dinged Oil Filler Caps to our new Restoration and Authenticity Forum.
I have attached as a PDF file which you can see by clicking on:
Replies to This Discussion
-
Permalink Reply by Jason Edge on
-
Oil filler cap in picture is available for $35 + s/h. I think that is more than fair with the rarity of these and work put into it. If interested email me at jasonedge@nc.rr.com. I have another one I will restore once I get a bit of time. Jason.
-
Permalink Reply by 0o31amnol21wu on
-
have these been cleaned and ready to use? i need one for my 64, i have some funky chrome one on it right now!
-
-
It has been restored. Click the blog for the PDF article and you will see it has been cleaned, sanded, filled, filed, primed, painted and ready to install. Here is the link again: http://storage.ning.com/topology/rest/1.0/file/get/2058129102?profi...
and what it looks like now:
-
-
I never added this to our Help Topics page. Just added.
Members
-
-
-
Travis J. Hensley Online
Forum
Convertible bumper jack
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 6 hours ago. 13 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Timing cover corrosion
Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion 9 hours ago. 0 Replies 0 Likes
Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue
Power steering fluid
Started by Bobby Brown in General Discussion. Last reply by Logan Robb 13 hours ago. 2 Replies 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
Dino Diaries - July 11, 2025 - Busted!
Started by Jason Edge in General Discussion. Last reply by Jason Edge on Saturday. 4 Replies 0 Likes
So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
-
July 20, 2024 - 63/64 Cadillac Chapter Zoom Meet-Up
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
Videos
© 2025 Created by Jason Edge.
Powered by
