Does anyone know where I can buy reproduction rubber floor mats like what came in my 63 from the dealer?

Views: 321

Reply to This

Replies to This Discussion

USA Parts & Supply (www.usapartssupply.com) has new original style reproduction 4 piece mat sets for $309. 95. OPGI (www.opgi.com) has the sets regular for $351.95, currently on sale for $319.99, so USA is still cheaper. Perhaps some of the other big suppliers might have them but I am not familiar with other sources.

Thank you big time, ordered them in red from usaparts, I've been looking all day and didn't find that site-the power of forums like this is amazing, thanks again

RSS

Photos

  • Add Photos
  • View All

Forum

Trivia #34 - What % of 1963 & 1964 Cadillacs Came with Tinted Glass

Started by Jason Edge in Trivia. Last reply by Dennis P. DiBari 2 hours ago. 5 Replies

What % of 1963 and 1964 Cadillacs came with the optional "soft ray" tented glass?  1963 & 1964 were very close, so if you get one you will get the other. Need to get it within 3%. So, who will…Continue

Trivia #33 - What % of 1963 Cadillacs Came with Limited Slip (Posi) Differential Rear End

Started by Jason Edge in Trivia. Last reply by Jason Edge yesterday. 3 Replies

It has been way too long since we posted any trivia (and gave out a cigar), so here is one I thought I might have posted but do not see it: What % of 1963 Cadillacs came with the optional "Controlled…Continue

1963 Coupe de Ville Located in NC For Sale

Started by Jason Edge in For Sale. Last reply by Jason Edge on Friday. 2 Replies

I had an older couple contact me indicating they are selling their 1963 Coupe de Ville they have had for 40 years and they are located Moyock, NC, which is in the very north east part of North…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Thursday. 15 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service