Yaw mounts
Hi Everyone
Does anyone know where I can get a set of new or good condition used Yaw mounts? I am located in South Australia Thanks
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
I have used yaw mounts, but I need to know what year and trans is i the car. <y email is russ@thecadishack.com
-
Permalink Reply by Phillip Hill on
-
Hi Russ
Thanks for reaching out i have a 63 deville with hydra matic transthe current Yaw mounts I have don’t have any rubber on them if you could advise me on a cost that would help
Could you take a look at the attached pic and tell me if the cross bar has been altered.i believe there has been a plate welded to the base or is this a standard part?
thanks again
- Attachments:
-
-
IMG_0254.jpeg, 4.6 MB
-
-
-
I believe that the convertible models did that for strength. I generally don't quote prices on line in forums because that is our business to discuss off line.
Send me and email and we can continue the conversation. russ@thecadishack.com
Members
Forum
Welcome Returning Member Maurice Hamelick from the Netherlands!
Started by Jason Edge in Chapter Discussion 1 hour ago. 0 Replies 1 Like
I wanted to give a shout out to returning Chapter Member Maurice Hamelick with his 1963 Four Window Sedan de Ville which was featured in our July 2016 Newsletter. Check out the newsletter via the…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 6 hours ago. 3 Replies 0 Likes
Rear suspension project
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 6 hours ago. 2 Replies 0 Likes
I have started my rear suspension project with the intent to replace bushings on the control links and yoke, shocks, coils and spherical joint. I have the car on jack stands and the transaxle…Continue
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Wednesday. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
