63/64 Cadillac Website

Yaw mounts

Hi Everyone

Does anyone know where I can get a set of new or good condition used Yaw mounts? I am located in South Australia Thanks

0 members like this

Facebook Facebook

▶ Reply to This

Replies to This Discussion

Permalink Reply by 3ft7bqmb7dryo on October 8, 2023 at 9:20am

I have used yaw mounts, but I need to know what year and trans is i the car. <y email is russ@thecadishack.com

▶ Reply

Permalink Reply by Phillip Hill on October 9, 2023 at 4:18am

Hi Russ
Thanks for reaching out i have a 63 deville with hydra matic trans

the current Yaw mounts I have don’t have any rubber on them if you could advise me on a cost that would help

Could you take a look at the attached pic and tell me if the cross bar has been altered.i believe there has been a plate welded to the base or is this a standard part?

thanks again

Attachments:

IMG_0254.jpeg, 4.6 MB

▶ Reply

Permalink Reply by 3ft7bqmb7dryo on October 9, 2023 at 9:07am

I believe that the convertible models did that for strength. I generally don't quote prices on line in forums because that is our business to discuss off line.

Send me and email and we can continue the conversation. russ@thecadishack.com

▶ Reply

RSS

Welcome to
63/64 Cadillac Website

Sign Up
or Sign In

Or sign in with:

Photos

Forum

Wanted Cadillac Lasalle 2 inch Windshield Decal Sticker

Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari yesterday. 3 Replies 0 Likes

for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies 0 Likes

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies 0 Likes

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies 4 Likes

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue