1964 Dealer Data Book

Reposting all pages scanned so far so they will be in page order. Will post remainder later.

  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo
  • photo

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on December 27, 2017 at 10:50am

The 1963 dealer data book is 120 pages and the 1964 dealer data book is 117 pages. Only some pages were scanned and posted in 2013 & 2014 as the spotlighted individual body styles during the 50th anniversary of their model year. I hope to get hi res picture or PDF scans of the entire book posted at some point.  

Comment by Anders on December 27, 2017 at 6:03am

Okay found the answer to my question. At least one answer. Fleabay has one for 250USD. Guess I need a bigger piggy then.

Comment by Anders on December 27, 2017 at 5:42am

So 63 pages and ending with Accessory and Equipment groups?

If ever finding an original 1964 Dealer Data Book in okay to good condition how much would it hurt the wallet? (So I know how much to start save up in the piggy).

Comment by Jason Edge on January 18, 2015 at 8:05pm

Deleted old album and reposted the 1964 Dealer Data Book page scans I have so far so they will post page # order.

Photos

  • Add Photos
  • View All

Forum

Surprised no feed back on the 65 429 rear crank bearing redesign change Service

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by Kurt 11 hours ago. 12 Replies

As the  rear crank bearing was redesigned in the 65  429 by Cadillac to reduce pressure on the RMS I thought it might be the answer to our endless leak issue many are having No one has found a…Continue

Love my car but hate the brakes - need some good advice

Started by Walter Anderson Bonner Jr. in General Discussion. Last reply by Mack on Thursday. 9 Replies

Need some advice: My car swerves when stopping.  The mechanic noticed the problem when he drove the car and he adjusted all of the vehicle’s drum brakes.   He, noted the brakes and drums looked good…Continue

Mark S Anderson

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion on Thursday. 0 Replies

Sent you a friend request Continue

Front Dash Speaker

Started by Michael Vogler in General Discussion. Last reply by Tony and Ginny 429 on Wednesday. 15 Replies

I want to replace the front dash speaker in my ‘64 De Ville Conv.  Do I really have to take the dash pad off, to access it from the top (As I read in the shop manual)? Or does anyone have tip to…Continue

Blog Posts

Rochester throttle body gasket

Posted by Phil on September 29, 2021 at 8:18am 5 Comments

Hello,  would anybody be able to tell me if I’m using the correct gasket on my Rochester throttle body? It doesn’t  look right to me.  I’m not sure if the carb actually ran with this gasket because I got it used with no history.  Any help would be appreciated …

Continue

Rumble Sound at 55-60 mph

Posted by Ray Schick on September 20, 2021 at 10:45pm 6 Comments

64 Coupe DeVille , while driving at 55-60 mph I have a oscillating rumble sound . Steering wheel does not shake or vibrate . Transmission mount looks good .Tires were replaced 2 years ago balanced and rebalanced recently. Axel bearings were just replaced, rear differential assembly was just replaced with a Posi track ,pinion bearings good. Fresh gear lube. Driveshaft checked and balanced the other day ,new center bearing installed and new bearing carrier assembly too. Trying to figure this…

Continue

1963 series 62 convertible transmission issue

Posted by Matthew VanDeWater on June 22, 2021 at 3:03pm 1 Comment

Hello I've been restoring a 63 for way to many years. Down to almost done, but have issue with trans linkage, when column in park shift rod 2 inches short. everything original. been trying to find picture of manual rod hooked up from under car to see position of linkage. was wondering if anybody has access for pictures. I wanted to see if my manual linkage is bent  wrong out of the trans if somebody dropped the trans or something. Doesn't make sense why it doesn't work. Thanks for any input…

Continue

New vehicle in the club

Posted by Patrick Westphal on June 17, 2021 at 4:00pm 1 Comment

I was successful in getting a vehicle from the New York contact I talked about at the last club meeting. I am still trying to figure out how to post a picture of the vehicle that is tied with this comment so if you see a random picture of a black convertible in a yard, that's me haha.  …

Continue

Videos

  • Add Videos
  • View All

© 2021   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service