Video From Jason's Garage (and House)

Here's a bit of video from the weekend working on the 63 CDV parts car I picked up in Florida from Rob. You will also see abit of my other project on the house porch ceiling!

I hadn't posted any video from the Garage in a While so thought taking the engine out of the 63 CDV would be a good opportunity. I've also been working on ou...

Facebook Facebook

Views: 336

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on March 28, 2013 at 7:39pm

Yeah. that was a grab the camera and video a bit. I knew the trans cooler pipe setup on the 63 but no picture references after recently looking for some, and was excited that this had the original LH side end to end. I had wanted to get some video too!

Comment by Jason Edge on March 28, 2013 at 7:42am
Good to hear from you Dan and look forward to reading and seeing progress on your Caddy. We have lots of knowledgeable members here so feel free to post in questions and updates on your progress. Regards, Jason
Comment by Jason Edge on March 10, 2013 at 10:08pm

Rob! You got the bumpers! LOL   I don't  know how many people asked about bumpers off that car when they heard I was bringing a 63 CDV in!  Seriously, this car had a lot of good stuff. Glad we could help each other out. Jason.

 

Photos

  • Add Photos
  • View All

Forum

Brake Booster not enough compression

Started by Rick Yasenchack in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Sunday. 8 Replies

I bought my 63 2-door convertible 62 series a few years back, previous owner said a new brake booster was just installed and that was why brake pedal was a rock.  Did not know.Just had engine…Continue

Add cruise control/Aftermarket Cruise control

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Michael Vogler on Sunday. 16 Replies

Late in the evenings, I wonder about things I will probably never do as I am not that crazy. However, I know someone out there has tried it or wanted it bad enough they have done it. My 64 Fltwd did…Continue

For sale; Hydra Matic transmission

Started by Russ Austin in General Discussion on Friday. 0 Replies

Known good Hydra Matic transmission for a 63 64 Cadi.Came out of my driving 63 coupe. I went the LS route.Resealed the pan, speedo drive, front and rear seals.Comes with a new rear…Continue

Houston we have a problem!

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Thursday. 5 Replies

While enjoying the fruits of my labor on all new rear suspension and…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service