Putting things back together under the hood and need to know how battery cables are routed and where negative cables hooks to engine.Please show pictures when replying if possible. Positive cable goes over radiator support I know but how is ground properly routed?
Tags:
Actually just returning home from a concert and saw the post... so just good timing!
A few more wiring questions:
1- The main wiring plug that comes thru the fire wall, where the antenna wire splits off there is another black wire that also splits foo at the same place. Where does it go? Ground to firewall?
2-Where does the DG wire come from that goes to the engine temp sensor come from?
Which leg of the main engine harness?
3-The yellow wire to the oil pressure sensor, it splits out of the harness and with it a black wire also splits out. Where does it go?
Pictures will help if possible with answers.
Thanks for any help guys
Wayne, I'm getting to ready to head out of town early tomorrow and will answer quickly. If you look at your wiring schematics it will answer most of your questions.
Here is a quick rundown.
1. Yes. Ground to firewall about 1" from there antenna cable comes through firewall. There is really only one place it can attach unless someone has drilled additional holes in the firewall.
2. Look at the picture I have already posted of cranking harness. You see the dark green wire on one end, now look up over top left and you see a connector with a green and yellow wire. The green wire and yellow wire attach to another connector with green wire and brown wire on other side right at the fuse box. Note the other connectors of the cranking harness that connects to the fuse box. That is your clue that it has to connect somewhere near the fuse box. The green wire on the other side goes to the temp gauge.
3. Yellow oil pressure wire goes through the firewall via the large Junction Block on fire wall. It is NOT part of the cranking harnesses assembly. This is clearly noted in the wiring schematics as it shows it going thru with the large junction block (2/3's down center of page).
Since this has gone way beyond battery cable routing it might be good to start breaking down the different wiring questions via separate posts since the latest involves antenna cable and ground, forward lamp harness oil sender unit wire, and the temp gauge wire routing. I would first study the wiring diagram. I answered 2 of your questions really without looking at a picture. The antenna wire question is a bit vague but the wiring does show a ground .. just doesn't give perspective of where it is, but since the short ground braid is only a couple inches long there is not much else it would connect to except the firewall. I don't mind helping but it is also good to familiarize yourself with the wiring schematic and just general layout of how wires run pt A to B in the Engine Component. If everything was already stripped out that makes things difficult. That is one ready I take a lot of pictures before I start removing anything.
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 18 hours ago. 14 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge yesterday. 6 Replies 0 Likes
First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system. The old system was very good, however, I believe what Bill and the…Continue
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Tuesday. 3 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Tuesday. 7 Replies 0 Likes
Greetings Everyone. I read a discussion thread about "radiator and related", covering coolant overflow. Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac? Is there if a…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by