The mast on my power antenna is stuck up.  I can hear the motor engage when I pull/push the knob, but no movement.  The mast seems be rigid on the push wire or rod which wont move.  Any thoughts about getting it unstuck?

Mike

Facebook Facebook

Views: 578

Reply to This

Replies to This Discussion

I can't stand a conceited (stuck up) antenna. Sorry, couldn't resist : ). Anyway, do you hear a clicking sound when the antenna motor is running? There is a nylon cord that pushes/pulls the mast up & down. If the mast is simply stuck you will hear a clicking sound as the nylon cord grips and breaks loose trying the move the mast. In this case check the mast for any dents or bends that could be binding it. Also oil the mast with WD40 on steel wool. Try pushing the mast down manually while someone else pulls the knob. It can't be lowered unless the motor is winding up the nylon cord, If you don't hear a clicking the nylon cord or something else may be broken. In that case, you would need to remove the antenna and open it up to investigate. Do you have a shop manual? Instructions for removing the antenna are there.

Thanks, Kurt. I have a shop manual and will get to reading!

You can get a new antenna mast from CaddyDaddy.com    I use them all the time. 

RSS

Photos

  • Add Photos
  • View All

Forum

Commercial Chassis Dual Battery Tray Questions

Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 15 hours ago. 2 Replies

I'm looking for some info and hopefully some pictures on the commercial chassis dual battery setup.  Is the second battery tray (driver side) , the same as the passenger side or is it mirrored?  I'm…Continue

Meet-Up of 1964 Cadillacs in downtown El Segundo Car Show August 16

Started by Jason Edge in Chapter Discussion 17 hours ago. 0 Replies

Chapter member Alan Clark and owner of a 1964 Eldorado sent this and wanted to share with everyone in case there are others nearby that might want to attend:"I'd like to invite the 63/64 chapter…Continue

The $120,000 1963 Eldorado on Bring a Trailer

Started by Jason Edge in General Discussion. Last reply by Jason Edge on Friday. 7 Replies

I have got a flood of email, texts, about the 63 Eldo that recently bid up to $120,000 and thought I would share for those that have not seen it.Here is the link:…Continue

Fuel Supply System - Check Points Beyond the Fuel Pump

Started by Jason Edge in General Discussion Aug 6. 0 Replies

Incredibly, in 3 days I have had 3 people ask about replacing their fuel pump or even adding an electric fuel pump because there carb is not getting gas.  It has gotten to the point I have copied and…Continue

Tags: System, Delivery, Fuel

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service