Hi Everyone 

Does anyone know where I can get a set of new or good condition used Yaw mounts? I am located in South Australia Thanks

Facebook Facebook

Views: 96

Reply to This

Replies to This Discussion

I have used yaw mounts, but I need to know what year and trans is i the car.  <y email is russ@thecadishack.com  

Hi Russ 
Thanks for reaching out i have a 63 deville with hydra matic trans

the current Yaw mounts I have don’t have any rubber on them if you could advise me on a cost that would help 

Could you take a look at the attached pic and tell me if the cross bar has been altered.i believe there has been a plate welded to the base or is this a standard part?

thanks again 

Attachments:

I believe that the convertible models did that for strength. I generally don't quote prices on line in forums because that is our business to discuss off line. 

Send me and email and we can continue the conversation.   russ@thecadishack.com  

RSS

Photos

  • Add Photos
  • View All

Forum

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 14 hours ago. 14 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Future of CLC Judging

Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge yesterday. 6 Replies

First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system.  The old system was very good, however, I believe what Bill and the…Continue

front seat crest

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Tuesday. 3 Replies

Original seats had a crest on the center arm rest.  Does anybody know where I could embose a crest in new material for a reupolstry?Continue

Coolant Overflow Bottle / Reservoir for 64 Cadillac Eldorado

Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Tuesday. 7 Replies

Greetings Everyone.  I read a discussion thread about "radiator and related", covering coolant overflow.  Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac?  Is there if a…Continue

Tags: Radiator, Bottle, Reservoir, Overflow, Coolant

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service