Kurt's Discussions (168)

Discussions Replied To (161) Replies Latest Activity

"It's possible that the seal started catching on the sleeve. Hopefully just an isolat…"

Kurt replied Oct 19 to Harmonic balancer seal and sleeve

6 Oct 20
Reply by Michael Buonaccorso

"I assume you lubed the seal & sleeve with oil, correct?"

Kurt replied Oct 19 to Harmonic balancer seal and sleeve

6 Oct 20
Reply by Michael Buonaccorso

"Click on the Help tab & scroll to "- Vacuum Schematics and Pictures" "

Kurt replied Oct 14 to Vacuum Line Through Firewall

2 Oct 15
Reply by Russ Austin

"You're right about the shape for the oil pump tool. I made one from an old tent pole…"

Kurt replied Oct 13 to Oil Press Light

22 Oct 13
Reply by Tony and Ginny 429

"Are you talking about the center (US spelling ; ) cap  on the steering wheel? You ca…"

Kurt replied Oct 13 to Steering wheel removal. (tilt column)

11 Oct 13
Reply by Kevin Campbell

"This just popped up if you are still looking http://6364cadillac.ning.com/forum/topi…"

Kurt replied Oct 4 to 64 CONVERTIBLE

3 Oct 5
Reply by Planet-automobile

"Very easy to take off the intake manifold. If you find out the problem is leaking ga…"

Kurt replied Oct 4 to Whining noise from outer space

29 Oct 16
Reply by Sammy

"Lee, Same here. I could have sworn it was coming from the carburetor so I rebuilt th…"

Kurt replied Oct 3 to Whining noise from outer space

29 Oct 16
Reply by Sammy

"Per the instructions posted, out (counter clockwise) lowers the pressure, in (clockw…"

Kurt replied Oct 1 to Diggn in the ac, hv some questions

30 Oct 2
Reply by Tony and Ginny 429

"You have to have something there, either the STV or the STV eliminator. With that sa…"

Kurt replied Oct 1 to Diggn in the ac, hv some questions

30 Oct 2
Reply by Tony and Ginny 429

RSS

Photos

  • Add Photos
  • View All

Forum

Bendix Power Brake Unit Power Section

Started by Mathis Richter in 1963/64 Cadillac Specific Discussion. Last reply by Chris Codd yesterday. 7 Replies

Hi,I have a huge problem my POWER SECTION of the ``Master-VAC Power Brake unit 9´´Diameter ´´ from Bendix is Broken and I can't open it to replace al the rubber parts did some of you have auch Power…Continue

Third brake light -help please.

Started by paul k in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 8 Replies

Did anybody from the club install third brake light in the rear window in his Cadillac? I have problem to figure out how to do it. Can I just run wire from break pedal switch and second wire connect…Continue

Extra speakers in the cadillac.

Started by paul k in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies

Ok, I have another question. Since I will run wire for a brake light I might run speakers wires.I would like to install 2 extra speakers or maybe 4. What is best option. I do have 2 speakers already-…Continue

429 and 400 trans. for sale

Started by Mark C Bills in For Sale. Last reply by Tony and Ginny 429 on Monday. 6 Replies

I have an excellent running 429 with 400 trans.recently removed from my 64. It has electronic ignition, new water pump,new fan and clutch(not pictured),new fuel pump,Holley 650 vac. sec. carb. with…Continue

Blog Posts

1964 Cadillac Fleetwood sixty special / transmission dipstick needed

Posted by Pablo on September 20, 2020 at 9:57pm 1 Comment

How are you doing folks, I’m looking for a transmission dipstick, any info I will appreciated, thank you very much

1963 Cadillac hood driver side hinge

Posted by Steven on September 16, 2020 at 9:23am 1 Comment

Hello,

 Does anyone know were I can buy a 1963 Cadillac hood driver side hinge or is there any other hinge that would fit? 

Thanks

Steven

Bad Guage?

Posted by Karl Schwarz on August 26, 2020 at 3:08pm 6 Comments

So I am troubleshooting my fuel gauge issue. I bought a new sender and tested it. It  it goes from 1-ohm (empty) to 35-ohm (full). When I test it (outside the tank), when the float is in the up (full) position it only moves the gauge to about 1/2 full. When at the bottom (empty) position the gauge shows empty. This is the same issue I have when I fill and then use the gas in the tank - the gauge never reads ore than half full. Based on what I've read on this thread it would seem like the…

Continue

Website

Posted by Fritz Seitz on August 11, 2020 at 2:35am 0 Comments

I have been working on a website-----www.fritzsautorepair.com-----

Does anyone have suggestions?

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service