Logan Robb's Discussions (236)

Discussions Replied To (168) Replies Latest Activity

"Yes correct. Where the tube goes into the pan. No seal there? Then what is this o ri…"

Logan Robb replied Mar 22, 2024 to TH400 Dipstick Tube Seal

9 Mar 25, 2024
Reply by Logan Robb

"This sounds like a good plan however, I don’t plan to remove my dash at this time. T…"

Logan Robb replied Mar 12, 2024 to Speedo Cable lubricant

4 Mar 12, 2024
Reply by Logan Robb

"May be worth inspecting the yaw mounts before jumping in too deep. Mine still might…"

Logan Robb replied Mar 10, 2024 to Yaw bumpers

11 Mar 10, 2024
Reply by Jason Edge

"Thanks for the link! Yeah, CD is always pricey, but in my experience, you are gettin…"

Logan Robb replied Mar 10, 2024 to Yaw bumpers

11 Mar 10, 2024
Reply by Jason Edge

"Yeah, rubber ready to ship would be preferable. Shouldn't need cores. Caddy Daddy ap…"

Logan Robb replied Mar 10, 2024 to Yaw bumpers

11 Mar 10, 2024
Reply by Jason Edge

"This is a good photo! Is there a reputable source for these yaw bumpers? Id like to…"

Logan Robb replied Mar 10, 2024 to Yaw bumpers

11 Mar 10, 2024
Reply by Jason Edge

""

Logan Robb replied Mar 9, 2024 to Speedo Cable lubricant

4 Mar 12, 2024
Reply by Logan Robb

""

Logan Robb replied Mar 9, 2024 to Speedo Cable lubricant

4 Mar 12, 2024
Reply by Logan Robb

"Would engine mounts be more accessible during this operation as well?"

Logan Robb replied Feb 3, 2024 to Transmission Mounts

2 Feb 3, 2024
Reply by Logan Robb

"Jason, have you got any horns available? I have the short trumpet horn but only one…"

Logan Robb replied Jan 15, 2024 to Cadillac horns

3 Jan 15, 2024
Reply by Jason Edge

RSS

Photos

  • Add Photos
  • View All

Forum

1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly

Started by Michael Monson in Wanted to Buy. Last reply by Michael Monson 6 hours ago. 2 Replies

Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering.  Also, possibly looking for an oil filter housing assembly for a 1964 429 motor.  Starting to get…Continue

Power Booster Install

Started by Rob Spring in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 20 hours ago. 6 Replies

Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue

Complete Front End Rebuild

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata on Thursday. 1 Reply

I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue

A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies

As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 13 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Events

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service