Ok so I started by following the instructions in the  shop manual and came to the part where it says remove 2 screws that attach the panel to the dash. I can't seem to find the 2 screws. has anyone ever done it without removing the cluster assembly?

Facebook Facebook

Views: 857

Reply to This

Replies to This Discussion

I asked myself last night after 3 hrs of going nuts. How bad do you need this to work? Just roll down the windows you have 8 to open and they are all power. are you nuts you live in the Midwest not the dessert. I can see where someone needed to save me from myself and quit and decide I would see what everyone had to say today. Well as I thought and see from all the comments. it's one big cluster F**** mess and I am into deep now to quit and will have a big smile on my face when it hits the 90's here and when at the shows and someone asks does the Air work and I can say yes Thank you all for the input and stand by as I may need a unit if someone has one and also I have to look but may need some dash bulb sockets as someone went thru here and broke a few sockets and ripped the wires from them Knew my Dash didn't light up right at night Thanks again all

Whereabouts in the Midwest Raymond?

Northwest suburbs of Chicago town called Roselle

After I asked the question, i noticed on your profile page where you were.

My wife and I will be in Illinois in 5 months time, but we won't make it over to your part of the state..... at least, I don't think we will, unless we're lost.

If ya see a rental car cruising around ya neighborhood with a couple of lost Aussies in it, ya might have to whack the jug on.  

Remove the dash pad and headlight switch. It's then a ten minute removal. I've had mine in and out twice. It will  come out the top of the dash with a couple of maneuvers. The dash and switch also come off pretty easy. On the 64's you just have to watch where you put your hand removing the dash or you will crush the in dash sensor.

As you see I got it done. now see the fan blower control the burnt fitting . Well I need only this if someone has one?

63 Fleetwood AC/Heater control panel with burnt out fan blower switch Assy.

As you see I got it done. now see the fan blower control the burnt fitting . Well I need only this if someone has one?

63 Fleetwood AC/Heater control panel with burnt out fan blower switch Assy.

Our 64 Fleetwood had suffered a similar short in the A/C at some point before we got it as well.

Our fuse box took a heap of heat through it too, so it would be wise to suss that out closely. My sparky was surprised our car hadn't burnt to the ground from it.

We now run, a brand new fuse box that accepts those plug in fuses.

I also run a fusable link at the battery as a safety exercise.

Mine had the same issue at some point in its life.  Burnt on/off switch, damaged fuse box and even melted ignition switch socket.  I went through my electrical system and replaced all of that when I restored my interior, and will be installing a fusible link at the starter (where all the power is sourced) like later 60's cars did.  Hopefully that will prevent it from happening again.

I have a fan switch.  Please email me at;  russ85747@hotmail.com   Include your zip code for a shipping quote.

RSS

Photos

  • Add Photos
  • View All

Forum

front seat crest

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch 12 hours ago. 3 Replies

Original seats had a crest on the center arm rest.  Does anybody know where I could embose a crest in new material for a reupolstry?Continue

Future of CLC Judging

Started by Jason Edge in Restoration Discussion. Last reply by Bill Wolf 22 hours ago. 3 Replies

First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system.  The old system was very good, however, I believe what Bill and the…Continue

Coolant Overflow Bottle / Reservoir for 64 Cadillac Eldorado

Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf 22 hours ago. 7 Replies

Greetings Everyone.  I read a discussion thread about "radiator and related", covering coolant overflow.  Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac?  Is there if a…Continue

Tags: Radiator, Bottle, Reservoir, Overflow, Coolant

Dino Radiator Leak - Time to Recore!

Started by Jason Edge in General Discussion. Last reply by Bill Wolf on Friday. 36 Replies

I had brought up the topic of radiator leaks as a discussion topic for our Chapter Zoom meet-up this past Sunday and thought I would share on our website for everyone and probably do a more formal…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service