Hey everyone, hope all is well and thanks in advance for the breadth of knowledge/info. this site provides...

I recently installed an air bag suspension kit to my 1964 Deville and needless to say the original alternator is struggling to keep up. I plan to add a sound system and am assuming that I'll need a 220 amp alternator, but wanted to see if anyone else has been successful going a different route??? To complicate the matter, I have an early built 1964 Deville that was given a 1963 390ci engine due to the factory's surplus (as opposed to a 429ci like most '64's). I found a 220amp alternator on Powerbastards.com, but it doesn't appear to be compatible with a '63 390 engine (I'm waiting for final confirmation)... Any assistance or feedback is greatly appreciated!

Thanks!

Mike

Views: 172

Reply to This

Replies to This Discussion

Boardie

This has come up before on this site
There are no 64 Cadillacs that came from the factory with a 390 engine
The 390 in a 64 has to be an engine swap at some point in time for that to be
By the nature of these cars being so old many things have been done to some to keep them on the road running well

Enjoy

As long as the casing has the same mount holes, it will work. You will need to run a single wire alt 9the GEN light will not work) or get the conversion kit that has a jumper plug and adaptor pig tail.

You will also need to rewire the charging wire harness to take the new amp charge.

Sure someone will be along shortly to help with you alternator question that has added the upgraded parts you have requiring more power

Enjoy

Curious as to what the VIN is on your engine. Why do you think it is a 63?

Thank you all for the feedback... I'm on the road for work, but will check the engine VIN against the car to confirm original vs. swap when I return. The original owner (technically second) advised me that it was built with a '63 engine and I could've sworn I saw something online that supported the possibility. I'll take the time to fully research.

Russ, appreciate the note on wiring/conversion kit.

Thanks!

The alternator listed for the '63 on that website is a Delco CS130 style alternator. It should physically mount in the bracket but it will need a pigtail wired to it to make it work. I have attached a basic wiring diagram for this alternator showing what it will take to make it work. Hope it helps.

Be wary. This style of alternator (CS130) is inherently poor in general. The unit has a small rear bearing and if excessive tension in applied to the pulley the rear bearing will suffer from premature failure. Proper belt tension is key to get the proper life out of these. 

Greg

Attachments:

Thanks Greg, appreciate the note and the diagram!

RSS

Photos

  • Add Photos
  • View All

Forum

Classic Cadillac Parts For Sale - Misc Items

Started by Jason Edge in For Sale. Last reply by Jason Edge 2 hours ago. 165 Replies

I have posted a few Misc items over on my Classic Cadillac Parts Facebook page at…Continue

Tags: classic cadillac parts, classiccadillacparts

Looking for 64 to 66 seat belt buckles, male and female together.

Started by Ryan Frawley in Wanted to Buy. Last reply by Tony and Ginny 429 yesterday. 5 Replies

Hey all, I am in the process of finishing up my 64 coupe deville and noticed that the front seat belts only have the retractor side in the bag I put all the belts in when I got it. I have found it…Continue

Tags: buckle, safety belt, seatbelt, seatbelts

Movie Star Cars.

Started by Kevin Campbell in General Discussion. Last reply by Kurt yesterday. 17 Replies

We have the Village Roadshow film studios about an 1.5 hour drive away.They've put out a call for cars to appear in a movie about Elvis. :-)So, I nominated our 64 Fleetwood as a potential "Movie Star…Continue

Current 1963/64 Cadillac Listings on eBay

Started by Jason Edge in For Sale. Last reply by Jason Edge yesterday. 0 Replies

To see all 1963/64 Cadillacs Listed on eBay in the USA…Continue

Tags: ebay

Blog Posts

Stuck at two red (dash) lights!

Posted by Jeff Kinzler on November 3, 2019 at 10:00pm 9 Comments

I hope someone can help solve these two electrical problems that appeared one after the other.

By way of background: The car, a '64 Eldorado has very limited use. It was at a restoration shop for 15 months until last January-  that supposedly did a bunch of wiring repairs including rebuilding the gas gauge that still hasn't worked properly, and the clock that hasn't worked, and re-soldering the broken wires in the drive door. All window and seat controls appear to be…

Continue

driveshaft help

Posted by wayne weaver on October 9, 2019 at 4:41pm 1 Comment

can anyone help me with a driveshaft ? I have a 1963 Cadillac 62 series 4dr with the hydro-matic trans. I need the male splined shaft on the front of the rear driveshaft section. the piece with the nut attached by clip.id be willing to buy a shaft if its not horribly priced.

Dash removal

Posted by Jake Mickley on October 9, 2019 at 12:06am 9 Comments

Hello everyone,

On a 63 CDV, if a guy wanted to remove the entire dash to get all the metal painted, and do some other things behind there, how would he go about doing that?  I checked here and the shop manual, but can't find a complete guide.

As always, and help or direction is appreciated.  Thanks!

--Jake

Introducing myself

Posted by Gary Marchand on October 7, 2019 at 9:32pm 8 Comments

Thanks for letting me join the club.  Picked up this ‘64 Coupe Deville a few months ago out of Beverly MA, the car has few stickers on it from various Cadillac clubs, didn’t know if anyone might recognize it from it’s “Glory days.” Everything seems pretty healthy except for the body and some very Mickey Mouse repairs, was wondering if anyone had any leads on…

Continue

Videos

  • Add Videos
  • View All

© 2019   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service