I need the metal hold down metal strap support that attaches to the cross brace to the passenger side hold down post on the 64 and also the small metal clip/loop that locates the positive cable as it passes over the same cross brace. genefattore@gmail.com
Tags:
Correct. I have a Group 60 sealed AGM reproduction AC Delco battery and I have reproduction hold down clamp and rods. I need the slim metal brace and cable locating loop as requested. Thank you.
Gene, I have the correct style white plastic battery cable hold down clip that goes on top of the radiator support for $10 + s/h. It is seen in the first picture below installed on my 64 CDV.
I say correct style as no one is make an exact reproduction of original which had a press in fastener with white plastic pin that pushes in and locks the clip in place. I've pulled in 44 parts cars and everything, including the 41K mile Fleetwood from a couple years back, had the top clip part broken off. The type I have and use is as close as I have found. To secure to the top of radiator support I use a small screw, lock washer and nut. Pictures 2 and 3 show what is usually left from the parts cars I bring in. The last picture is from the 1964 serviceman bulletin with happens to have a good picture confirming the original setup.
Clip installed on my 64 CDV:
bather Cable Clip Base and push in pin as seen on parts cars...
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch 27 minutes ago. 3 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
Started by Jason Edge in Restoration Discussion. Last reply by Bill Wolf 10 hours ago. 3 Replies 0 Likes
First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system. The old system was very good, however, I believe what Bill and the…Continue
Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf 11 hours ago. 7 Replies 0 Likes
Greetings Everyone. I read a discussion thread about "radiator and related", covering coolant overflow. Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac? Is there if a…Continue
Started by Jason Edge in General Discussion. Last reply by Bill Wolf on Friday. 36 Replies 0 Likes
I had brought up the topic of radiator leaks as a discussion topic for our Chapter Zoom meet-up this past Sunday and thought I would share on our website for everyone and probably do a more formal…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
© 2025 Created by Jason Edge.
Powered by