bulb for door handle 1963 Cadillac
My lights in the side door panel are out on the driver and front passenger side of my 63. The back lights work on the door side panels
Do you know where I might get bulbs and what I would reference to obtain those parts.
Replies to This Discussion
-
Permalink Reply by Jason Edge on
-
Hi David, They are a #212 bulb and available at Wal Mart, Amazon and most auto parts stores. If you don't have a store nearby I have them new for $2 each, or $4 for the pair which drops to $3 with Chapter Discount. I can ship 2-3 day Priority for $10 for a total of $13. If interested shoot me a PayPal to jasonedge64@outlook.com. If you need an invoice sent email to me at same jasonedge64@outlook.com.
-
Permalink Reply by David Erickson on
-
Thanks Jason. I will try here first and if not available will order from you. Are they hard to install? I am a novice at repairs.
-
-
Disconnect battery and gently pry the lens cover off with a very small screwdriver or jeweler's tool.
-
-
Thank you Jason. David
Members
Forum
Rear main seal
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson 6 hours ago. 5 Replies 0 Likes
Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue
Logans Intake Project, 1964 Fleetwood, Progress Report #2
Started by Logan Robb in 1963/64 Cadillac Specific Discussion 8 hours ago. 0 Replies 0 Likes
Hello all!Just a short update this evening!I wrestled with the exhaust manifold studs and ultimately chickened out on replacing all 4 of the studs. I only replaced the stud that I spun the threads…Continue
Scout Shows up in the Garage with "Man Bun" to Work on Cadillac!
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 12 hours ago. 1 Reply 0 Likes
Cheryl brought my 4 1/2 month old boy Scout out to the garage in a man-bun to help work on the Cadillac. Sometimes you just have to roll with it! (I am scared to see who she will "dress up" Bandit…Continue
Logans Intake Project, 1964 Fleetwood, Progress Report #1
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb 20 hours ago. 5 Replies 0 Likes
I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
